Thank you for purchasing the Datapath
IQS4 4k quad splitter. The aim of this
document is to quickly guide you through
the process of initial setup.
For detailed information, the User
Guide can be downloaded from
www.datapath.co.uk.
CONTENTS
Your packing box contains the following items:
Your IQS4 4k Quad Splitter
Power Supply Unit
5xHDMI Locks
4xM4 Mounting Screws
Note: All Products are static sensitive and
are packed in antistatic materials. Please
keep the IQS4 in its packaging until you are
ready to install.
INSTALLATION
Installing your IQS4 is a simple process. In summary,
the following steps need to taken to be up and
running in a few minutes:
1. Each IQS4 has a VESA mount which enables the
unit to be xed to the rear of a display should this
be a requirement.
2. Connect the output of the graphics card to the
input socket on the rear of the IQS4 using an HDMI
cable. Ensure the cable is secured into the IQS4
input connector using the supplied cable lock.
3. Connect the outputs on the IQS4 to your displays.
Ensure the cables are secured into the IQS4 output
connectors using the supplied cable locks.
4. Connect power supply and switch on,
5. Right click on the desktop and select the Display
Driver Conguration Tool (DDCT) from the menu.
Follow the instructions to congure your displays.
Full details of the DDCT can be found in application
help le and the Image card User Guide located on
the Datapath website.
www.datapath.co.uk
CONNECTIONS
COPYRIGHT STATEMENT
© Datapath Ltd., England 2020.
Datapath Limited claims copyright on this
documentation. No part of this documentation
may be reproduced, released, disclosed, stored in
any electronic format, or used in whole or in part for
any purpose other than stated herein without the
express permission of Datapath Limited.
Whilst every eort is made to ensure that the
information contained in this documentation is
correct, Datapath Limited make no representations
or warranties with respect to the contents thereof,
and do not accept liability for any errors or omissions.
Datapath reserves the right to change
specication without prior notice and cannot
assume responsibility for the use made of the
information supplied. All registered trademarks
used within this documentation are acknowledged
by Datapath Limited.
Outputs from the IQS4 can be connected to any four
screens on the wall, the DDCT will work out the correct
conguration.
It should be noted that the HDMI Input connector requires
a source resolution of 7680x1080@60Hz.
IQS4 Quick Start GuideIQS4 Quick Start Guide
