POPP Cummunicatios spa 500s User manual

Brand: POPP Cummunicatios

Model: spa 500s

Category: IP phones

Type: User manual

Hosted IP Phone System

SPA 500S 32 Button Sidecar User Guide

Service 24x7 @ 763-797-7900 or 1-800-234-POPP

Page 1 of 3 5/21/15

Adding a Cisco SPA 500S Sidecar

Follow the instructions below to connect a Cisco SPA 500S Sidecar to an existing Cisco

SPA 500 Series Telephone.

Connecting a Sidecar to an Existing Cisco Telephone

The following procedure describes how to attach a Cisco SPA 500S Sidecar

(referred to as “Sidecar” below) to a Cisco SPA 500 Series Telephone (referred

to as “Telephone” below).

 Unplug the Ethernet cord from the “SW” port on the back of the Telephone

 Remove the desktop phone stand

 Turn both the Telephone and the Sidecar face down (see below)

 Align the IP phone screw hole in the Telephone with one of the holes on the attachment arm and insert the pegs into

the peg holes

 Holding the attachment arm in place, place an attachment arm screw into the IP phone screw hole and secure the

attachment arm to the Telephone

 Align the right screw hole in the Sidecar with the unused hole on the attachment arm and insert the pegs into the peg

holes on the Sidecar

 Using an attachment arm screw, secure the attachment arm to the Sidecar

Hosted IP Phone System

SPA 500S 32 Button Sidecar User Guide

Service 24x7 @ 763-797-7900 or 1-800-234-POPP

Page 2 of 3 5/21/15

 Locate the AUX IN port on the back of the Sidecar. Connect one end of the auxiliary cable to this port.

Note: Do not plug a telephone line cord into the AUX port. Use only the auxiliary cable provided with the Sidecar.

 Locate the AUX port on the back of the Telephone. Connect the other end of the auxiliary cable to this port. The

Sidecar is powered by the auxiliary cable with the Telephone and no additional power source is required.

 Route the auxiliary cable into the cable slot of the Sidecar

 To attach a second Sidecar (optional – a maximum of two Sidecars can be connected to a Cisco Telephone): Insert the

attachment arm into the peg holes of the first and second Sidecar and use the attachment arm screws to secure it in

place. Plug the auxiliary cable into the AUX OUT port of the first Sidecar and the AUX IN port of the second Sidecar.

Route the auxiliary cable into the cable slot.

Hosted IP Phone System

SPA 500S 32 Button Sidecar User Guide

Service 24x7 @ 763-797-7900 or 1-800-234-POPP

Page 3 of 3 5/21/15

 Attach the appropriate desktop stand to each unit.

Complete Sidecar Setup

Plug the Ethernet cord into the “SW” port on the back of the Telephone. The telephone may take a few minutes to boot up

with the sidecar button configuration (preconfigured by POPP). Once the telephone reboot has completed, you can start

using your new Sidecar(s).

For Additional Training and Support

 Visit www.popp.com ”Support””Hosted IP Phone System Resources”

 Call POPP Communications at 763-797-7900

POPP Cummunicatios spa 500s User manual

Brand: POPP Cummunicatios

Model: spa 500s

Category: IP phones

Type: User manual

Download PDF

report

POPP Cummunicatios spa 500s User manual

POPP Cummunicatios spa 500s User manual

Other documents