C2G Multi-Modular Cable Tester Datasheet

Multi-Modular Cable Tester

The Multi-Modular Cable Tester is specifically designed to test modular-terminated (RJ45, RJ11, RJ12) for wire

continuity and miswiring. It can be used to test a variety of pin configurations such as USOC 4, USOC 6 and USOC 8, no

matter whether the pins are crossed or wired straight through. Moreover, with the remote terminator, you may perform all

of the above tests on installed cables.

Features:

Determines continuity faults for modular cables with

RJ11/RJ12/RJ45 connections

●

Compares wiring configuration to USOC 4/USOC

6/USOC 8 standards

●

Identifies wiring shorts, open wires, crossed pairs,

reversed pairs and miswiring

●

Tests installed cables with included remote terminator●

Includes storage pouch●

Order information:

250451 Multi-Modular Cable Tester

This manual is also suitable for