1 2
3
4
SHFTPPH10
Quick Start Guide
100 Watts Hi-Fi
Component System
5
The Amplifier
Unpacking
Connections
Clock Setting
Connecting the DAB/FM Aerial
Connect the DAB/FM wire aerial to the DAB/FM aerial socket on the rear of the CD player.
1
Speaker Connections
Connect the speaker cables at the rear of the speakers to the speaker sockets (L/R) at the rear side of the amplifier.
2
Connecting the Control Cable
Connect the control cable between the CD player and the amplifier.
3
Connecting to the Mains Supply
Insert the mains plug into a wall socket. Your system is now ready to use.
4
You will find that there are many exciting features available.
To get to know all these features, please take some time to read the instruction manual provided.
Remove all item from the packaging. Retain the
packaging.
If you dispose of it please do so according to any local
regulations.
Operating Your Remote Control
QSG-SHFTPPH10-140617V5
Thank you for purchasing your new Sandstrøm Hi-Fi.
Please follow this quick start guide for a successful first time set up.
We recommend that you spend some time reading the instruction manual in order
to fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep the instruction
manual for future reference.
Please ensure that the mains cable is DISCONNECTED from the mains socket before connecting any cables.
Install the batteries correctly by following the polarity (+ and -)
indications in the battery compartment.
Tip:
Basic Operation
Switching the unit On
Press the STANDBY button at the front or on the
remote control to switch the unit on.
Selecting Modes
Press the IN button on the unit repeatedly to select
CD, USB, FM, DAB or AUX mode.
You can also press the short-cut buttons on the
remote control ( FM/DAB, CD, USB, AUX ) to select
your desired mode.
CD Player Speakers x 2
Remote Control
Amplifier
Instruction Manual
DAB/FM Aerial
Control Cable
Quick Start Guide
2. Insert two AAA size batteries (not included).
Make sure the (+) and (–) ends of the batteries
match the (+) and (–) ends indicated in the
battery compartment.
1. Press and slide the back cover to open the
battery compartment of the remote control.
3. Close the battery compartment cover.
Right Speaker Box
The CD Player
Left Speaker BoxBack View
Connecting the
DAB/FM Aerial
Connecting the
Control Cable
Connecting to the
Mains Supply
Speaker Connections
2 2
2
4
3
1
CD USB FM
DABAUX
On the top cover
of CD player
STANDBY
IN
Instruction
Manual
Quick Start Guide
OPEN
Setting the Clock Automatically
Tune into either a DAB or RDS station and the clock
will be automatically set within a few minutes.
Setting the Clock Manually
1. Set the unit to Standby mode.
2. Press the CLOCK button
on the remote control,
“CLOCK 24HR” will show
and “24” will blink. Set the
clock to 12 or 24 hour format
with the VOL +/– buttons.
Press the CLOCK button again,
the hour indicator will blink.
3. Set the hour with the
VOL +/– buttons.
4. Press the CLOCK button again,
the minute indicator will blink.
5. Set the minute with VOL +/–
buttons.
6. Press the CLOCK button, the
built-in clock starts operating.
SHFTPPH10_QSG_RC_140617_Zell.pdf 1 17/6/14 11:04 am
-
1
