Cleveland Range KEL-80-T Datasheet

Cleveland Range
Brand
Cleveland Range
Model
KEL-80-T
Category
Flat panel accessories
Type
Datasheet

This manual is also suitable for

Cleveland Range KEL-80-T is a self-contained electric kettle with a capacity of 80 gallons (300 liters). It is designed for tilting, has a splash-proof construction, and is self-contained, requiring only an electrical hook-up for installation.

The kettle features accurate, consistent solid-state temperature controls with a variance of less than ±1°C, making it ideal for simmering. The operating temperature range is from 145° to 260°F (63°C to 127°C). The control panel includes LED indicators for the heat cycle and low water level, a power ON/OFF switch, and an adjustable temperature control dial.

Cleveland Range KEL-80-T is a self-contained electric kettle with a capacity of 80 gallons (300 liters). It is designed for tilting, has a splash-proof construction, and is self-contained, requiring only an electrical hook-up for installation.

The kettle features accurate, consistent solid-state temperature controls with a variance of less than ±1°C, making it ideal for simmering. The operating temperature range is from 145° to 260°F (63°C to 127°C). The control panel includes LED indicators for the heat cycle and low water level, a power ON/OFF switch, and an adjustable temperature control dial.

Cleveland
™
P
roject ________________________________
Item __________________________________
Quantity _______________________________
F
CSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
ELECTRIC KETTLES
SECT. VIII PAGE 11
0609
Cleveland Standard Features
II
Self-contained, easily installed - needs only an electrical hook-up
II
Steam jacket filled with treated water, venting and/or refilling is
not required
II
Accurate, consistant solid state temperature controls (mechani-
cal thermostate not as accurate) - less than ±1°C variance
(ideal for simmering). Operating temperature range from 145° -
260°F (63°C - 127°C)
Control panel includes:
• LED indicator for heat cycle • LED indicator for low water
• Power ON/OFF switch • Adjustable temperature control dial
II
Water resistant controls, splash-proof construction
II
Large pouring lip for high capacity and chunky products
II
Re-inforced rolled rim design prevents damage to kettle rim,
eliminates "bar rim designs"
II
Welded-in heating elements, (holds vacuum better, won't leak
or loose water)
II
Easily cleaned: kettle and all exterior surfaces are of type 304
stainless steel with an #4 finish
II
Rear mounted easy access pressure gauge and pressure relief
valve to prevent tampering. Color coded easy to read pressure
gauge with "green" and "vent air zone"
II
50 psi steam jacket rating for higher cooking temperatures
II
50 psi safety valve
II
Solid state water level control (no sight glass gauge to break or leak)
II
Splash proof element cover with a double gasket seal
II
Tilt mechanism of roller bearings and case hardened
self-locking worm and segment gear
II
1 5/8˝ O.D. tri-leg supports with level adjustable feet for floor bolting
II
Standard voltage is 208-240 volts, 60 Hz, 3-phase, 3-wire
II
Typical approvals include UL., CSA, CE, NSF and ASME
Options & Accessories
Ë
Spring-assisted, hinged, rotatable, domed Stainless Steel Cover (CHS)
Ë 2˝ or 3" diameter Tangent Draw-Off Valve (TD2 or TD3*)
*TD3 will raise height of kettle by 5-5/8" (143mm)
Ë Hot and Cold Water Faucet with Swing Spout and Mounting
Bracket (DPK and FBKT)
Ë Type 316 Stainless Steel Kettle Liner for high acid food
products (316)
Ë Pan Carrier (PCK)
Ë Flow Diverter (FD)
Ë Food Strainers (FS)
Ë Cooking Baskets and Tri-Basket Supports (BS and TBS)
Ë Kettle Accessory Kit (KAK) includes:
Ë Clean-up Brush (CB) Ë 36˝ Kettle Paddle (KP)
Ë 36˝ Kettle Whip (KW) Ë 36˝ Kettle Brush
Ë Draw-Off Brush (DB) Ë 24 oz. Ladle (KL)
Ë Automatic Water Meter (GMF or LMF)
Shall be CLEVELAND, Electric Kettle, Quad-leg mounted, self-con-
tained, tilting, Model KEL - _____ - T; _____ gallons, 2⁄3 Steam
Jacketed. Type 304 Stainless Steel Kettle and Supports. 50 psi
Steam Jacket Rating; 50 psi Safety Valve; Permanently filled Steam
Jacket; Combination Pressure/Vacuum Jacket Gauge. Splash Proof
Solid State Temperature (±1° C) and Safety Control System in plug-
in Module including L.E.D. indicators,
Ë Drain Strainers (DS-)
Ë Water Meter Stand (SWM)
Ë Lift-Off Covers (CL)
Ë Measuring Strip (MS)
Ë Gallon Markings (KM)
Ë Hot and cold or cold only Kettle Filler with 60˝ Hose (DKF-K or
SKF-K)
Ë Swing Funnels for drain (SW)
Ë Alternate Mounting Systems
Ë High Wattage (HW)
Ë Special Voltages
Ë High Wattage (HW) (see back page)
Ë Special Voltages (see back page)
Ë Heat Deflector Shield (HS001)
Ë Correctional Packages
Short Form Specifications
Shown with optional spring-assisted
cover and 2" tangent draw-off valve
QUAD-LEG, ELECTRIC KETTLES
TILTING, “
SPLASH PROOF SERIES”,
SELF-CONTAINED, 2⁄3 STEAM JACKETED,
80 or 100 GALLONS (300 or 375 LITERS)
MODELS: KEL-80-T KEL-100-T
(NOT TO SCALE)
SECT. VIII PAGE 12
0609
Litho in U.S.A.
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., NSF, CGA, CSA, ETL and others.
Z
G
F
E
KETTLE SHOWN WITH OPTIONAL SPRING ASSIST COVER,
WATER FAUCET AND T.D. VAVLE.
HANDWHEEL
REPLACED BY
S
WITCH FOR
POWER
TILT OPTION
H
(
I.D.)
2" T.D. VALVE
(AS SHOWN)
W
ALL
C
H
MANUAL TILT
E
XTENDED
FOR POWER
T
ILT OPTION
T
V
U
P
OWER TILT
TANGENT
DRAW-OFF
V
ALVE
S
A2
P
X
FOOT LOCATION AND
F
LOOR DRAIN DETAIL
Y
L
M
Q
W
J
L
N
FLOOR
D
RAIN
DETAIL
2 3/4"
70
mm
REF
2
3/4"
70
mm
WALL
A1
SOLID FOOT DETAIL
5 1/2" (140 mm)
3/8"
(10 mm)
2"
(51
mm)
1" (26
mm)
MAX. ADJUSTMENT
5/8"
Ø
(16
mm)
2 HOLES
ON 4"
(102
mm)
B.C.D.
RECOMMENDED
FLOOR SLOPE
1" (26 mm) per 4' (1220 mm)
PIPE DRAIN RECOMMENDED
min. valve size plus 1" (26 mm)
4" (102 mm)
RECOMMENDED
N
OTE: TD3, 3" tangent draw off will
raise height of kettle by 5-5/8" (143mm).
CAPACITIES: (in 8 oz. servings,
other sizes may be calculated)
80 Gallon / 300 liters . . . 1280 servings
100 Gallon / 375 liters . . . 1600 servings
CLEARANCE
WATER
3
⁄8˝ O.D. copper tube or
1
⁄2˝ N.P.T. pipe.
When ordered with
optional faucet.
H
C
RIGHT = 4.0˝ handle
clearance
LEFT = .00˝
REAR = .00˝
STANDARD WATTAGE
208V 240V 415V 480V
AMPS AMPS AMPS AMPS AMPS AMPS AMPS AMPS
GALS. LITERS KW 1PH 3PH KW 1PH 3PH KW 1PH 3PH KW 1 PH 3PH
80 300 14.7 70.8 40.9 19.6 81.7 47.1 18.1 43.5 25.1 19.6 40.8 23.6
100 375 14.7 70.8 40.9 19.6 81.7 47.1 18.1 43.5 25.1 19.6 40.8 23.6
HIGH WATTAGE
208V 240V 415V 480V
AMPS AMPS AMPS AMPS AMPS AMPS AMPS AMPS
GALS. LITERS KW 1PH 3PH KW 1PH 3PH KW 1PH 3PH KW 1 PH 3PH
80 300 29.4 NA 81.7 39.2 NA 94.3 36.2 87.0 50.2 39.2 81.7 47.1
100 375 29.4 NA 81.7 39.2 NA 94.3 36.2 87.0 50.2 39.2 81.7 47.1
DIMENSIONS
GALS./
LITERS A1 A2 EFGHJLMNPQSTUVWXYZ
80/ IN 48 1/2 54 1/8 84 47 7/16 17 33 24 1/4 11 3/8 32 1/2 67 3/8 35 1/2 5 1/2 48 44 5/8 8 5/8 40 1/4 21 1/2 40 3/4 24 1/4 52 1/8
300 mm 1232 1375 2134 1205 432 839 616 289 826 1712 902 140 1220 1134 220 1023 547 1036 62 133
100/ IN 51 56 5/8 89 7/8 48 11/16 16 1/4 35 1/2 25 5/8 11 5/8 36 71 1/4 40 1/2 4 49 1/2 47 9 1/4 40 23 43 1/4 25 5/8 53 3/8
375 mm 1296 1439 2283 1237 413 902 651 296 915 1810 1029 103 1258 1194 235 1016 585 1099 651 1355.8
Consult factory for other voltages.
  • Page 1 1
  • Page 2 2

Cleveland Range KEL-80-T Datasheet

Cleveland Range
Brand
Cleveland Range
Model
KEL-80-T
Category
Flat panel accessories
Type
Datasheet
This manual is also suitable for

Cleveland Range KEL-80-T is a self-contained electric kettle with a capacity of 80 gallons (300 liters). It is designed for tilting, has a splash-proof construction, and is self-contained, requiring only an electrical hook-up for installation.

The kettle features accurate, consistent solid-state temperature controls with a variance of less than ±1°C, making it ideal for simmering. The operating temperature range is from 145° to 260°F (63°C to 127°C). The control panel includes LED indicators for the heat cycle and low water level, a power ON/OFF switch, and an adjustable temperature control dial.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents