Panasonic kx-tg8120fx Operating instructions
- Category
- Telephones
- Type
- Operating instructions
This manual is also suitable for
PQQW15190ZA DC0306DT0
FX-2/3
Digital Cordless Phone
Model No. KX-TG8100FX
Digital Cordless Answering System
Model No. KX-TG8120FX
To use this product in Czech or Slovakia, change the unit’s region setting to match your
country.
Refer to “Changing the unit’s region settings” in the operating instructions.
1 Connections
Quick Guide
(220–240 V, 50 Hz)
To telephone network
Hook
Use only the included AC adaptor
and telephone line cord.
TG8100_8120FX(e-e)_QG.fm Page 1 Tuesday, March 28, 2006 7:32 PM
– 2 –
2 Battery installation/
Battery charge (Initial charge: 7 hours)
Note:
L Use only the included rechargeable batteries.
3 Screen saver mode
The backlight will turn off completely after 1 minute of inactivity if the handset is not on
the base unit.
To use the handset when it is in screen saver mode, first press {ih} to turn the display on
again.
4 Symbols used in these operating instructions
*1 KX-TG8100 only
*2 KX-TG8120 only
Symbol Meaning
" Press " (middle soft key).
i Proceed to the next operation.
# Press # (middle soft key).
j (“Caller List”)
X (“SMS”)
K (“Time Settings”)
*1
I (“Answer System”)
*2
N (“Handset Setup”)
L (“Base Unit Setup”)
M (“Display Setup”)
Select the mentioned handset menu icon.
Example: N (handset setup menu icon)
Select N by pressing {^}, {V}, {<}, or {>}.
“” Select the words in quotations shown on the display (e.g.,
“Time Settings”) by pressing {^} or {V}.
*The pictured model is KX-TG8100.
Charge contact
TG8100_8120FX(e-e)_QG.fm Page 2 Tuesday, March 28, 2006 7:32 PM
– 3 –
Display language
16 display languages are available.
You can select “Deutsch”, “English”, “Magyar”, “Polski”, “slovensky”,
“ČeŠtina”, “Hrvatski”, “Slovenscina”, “Eesti”, “LIETUVIŠKAI”, “LatvieŠu”,
“Românã”, “БЪЛГАРСКИ”, “Srpski”, “МАКЕДОНСКИ”, or “Shqiptar”.
1 {ih} i " (middle soft key)
2 Select N by pressing {^}, {V}, {<}, or {>}. i # (middle soft key)
3 Press {^} or {V} to select “Display Setup”. i #
4 Press {^} or {V} to select “Select Language”. i #
5 Press {^} or {V} to select the desired language. i # i {ih}
Note:
L If you select a language you cannot read, press {ih}, ", press {V}, press #, press
{V} 2 times, press #, press {V} 3 times, press #, select the desired language, then
press #. Press {ih}.
Dialling Mode
1
" (middle soft key)
2 Select L by pressing {^}, {V}, {<}, or {>}. i # (middle soft key)
3 Press {^} or {V} to select “Call Options”. i #
4 Press {^} or {V} to select “Dial Mode”. i #
5 Press {^} or {V} to select the desired setting. i # i {ih}
Date and time
1
" (middle soft key)
2 Select N by pressing {^}, {V}, {<}, or {>}. i # (middle soft key)
3 Press {^} or {V} to select “Time Settings”. i #
4 Press {^} or {V} to select “Set Date & Time”. i #
5 Enter the current day, month, and year.
6 Enter the current hour and minute.
7 # i {ih}
TG8100_8120FX(e-e)_QG.fm Page 3 Tuesday, March 28, 2006 7:32 PM
– 4 –
5 Basic operations
Answering system (KX-TG8120 only)
Feature Operation
Making a call Dial the phone number. i {C}/{s}
Answering a call {C}
Hanging up {ih}
Receiver/speaker volume Press {^} or {V} while on a call.
Last number redial B (right soft key) i {C}
Making a call with redial list B (right soft key) i Press {^} or {V} to select the
desired number. i {C}
Handset phonebook: storing
an entry (name and phone
numbers)
H (left soft key) i " i “New Entry” i #
i Enter the party’s name (16 characters max.). i #
i Enter the party’s phone number (24 digits max.). i
# i Select the desired category. i # i
“Save” i # i {ih}
L To enter a name, see the character table in the
operating instructions.
Handset phonebook:
making a call
H (left soft key) i Press {^} or {V} to display the
desired entry. i {C}
Handset ringer volume " (middle soft key) i N i # i “Ringer
Setup” i # i “Ringer Volume” i # i
Press {^} or {V} to select the desired volume. i #
i {ih}
Changing ringtone
(outside calls)
" (middle soft key) i N i # i “Ringer
Setup” i # i “Ext. Ringtone” i # i
Select the desired ringtone. i # i {ih}
Feature Operation
Answering on/off " (middle soft key) i I i # i “Answer On”
or “Answer Off” i # i {ih}
Listening to messages " (middle soft key) i I i # i “Play New
Msg.” or “Play All Msg.” i #
TG8100_8120FX(e-e)_QG.fm Page 4 Tuesday, March 28, 2006 7:32 PM
– 5 –
6 Frequently asked questions
Question Cause & solution
What kind of power outlet
should I connect the AC
adaptor to?
Connect the AC adaptor to a 220–240 V outlet.
Why is w flashing? L The handset is too far from the base unit. Move closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area with
high electrical interference. Place the handset and base
unit away from interference sources, such as antenna
and mobile phones.
L The handset is not registered to the base unit. Register it.
" (middle soft key) i N i # i
“Registration” i # i “Register H.set” i
# i Select a base unit number. i # i Press
and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds. i Wait until “Enter Base
PIN” is displayed. i Enter the base unit PIN (default:
“0000”). i #
Why can I not make calls? The dialling mode setting is incorrect. Set to “Tone” or
“Pulse” as needed.
Why is the handset display
blank?
L The handset is in screen saver mode. Press {ih} to
activate the handset display again.
L The handset is not turned on. To turn the power on, press
{ih} for about 1 second.
What should I do when the
handset does not turn on?
L Make sure that the batteries are installed correctly.
L Fully charge the batteries.
L Clean the charge contacts and charge again.
How long should I charge new
batteries?
Charge the batteries for about 7 hours.
How long is the battery
operating time?
When you are using fully-charged Ni-MH batteries
(included batteries);
In continuous use: 12 hours max.
In continuous standby mode: 150 hours max.
L It is normal for batteries not to reach full capacity at the
initial charge. Maximum battery performance is reached
after a few complete cycles of charge/discharge (use).
L Actual battery performance depends on a combination of
how often the handset is in use and how often it is not in
use (standby).
TG8100_8120FX(e-e)_QG.fm Page 5 Tuesday, March 28, 2006 7:32 PM
– 6 –
7 Optional services (Caller ID and SMS)
If you subscribe to Caller ID service, you can:
Can I keep the handset on the
base unit when I am not using
it?
L Even after the handset is fully charged, the handset can
be left on the base unit without any ill effect on the
batteries.
When should I replace the
batteries?
If the batteries are fully charged until
1
is displayed, but
3
is displayed after a few calls, replace the batteries with
new ones.
What is a PIN? The PIN is a 4-digit number that must be entered in order
to change certain base unit settings. The default PIN is
“0000”.
What do I need to do to
display caller information?
L You need to subscribe to Caller ID service. Consult your
service provider/telephone company for details.
L The message “You must first subscribe to
Caller ID.” will be displayed until you receive caller
information after subscribing to Caller ID service.
– display caller information
– identify who is calling by using different display colours and ringtones
(handset phonebook category)
To use SMS, you must subscribe to Caller ID and/or appropriate service.
SMS (Short Message Service)
Question Cause & solution
Tom
012345
Tom
012345
TG8100_8120FX(e-e)_QG.fm Page 6 Tuesday, March 28, 2006 7:32 PM
-
1
-
2
-
3
-
4
-
5
-
6
Panasonic kx-tg8120fx Operating instructions
- Category
- Telephones
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Panasonic KXTG8102E Operating instructions
-
-
-
-
-
-
-
-
-