Spin Master Air Hogs Zero Gravity Micro Wall Racer Operating instructions

Brand: Spin Master

Model: Air Hogs Zero Gravity Micro Wall Racer

Type: Operating instructions

Spin Master Air Hogs Zero Gravity Micro Wall Racer defies gravity with its wall-climbing ability, featuring a suction throttle that allows full function while scaling walls. It's perfect for indoor use and comes with a controller/charger. The vehicle has pre-installed rechargeable batteries and can be charged in 20-40 minutes. It also has working headlights to indicate low battery. Drive on walls or the ground, but avoid obstacles and edges. Use the joysticks to control direction and spins. If it doesn't drive straight, use the trim adjusters. Clean tires and surfaces for better grip.

GETTING TO KNOW YOUR ZERO GRAVITY MICRO™ WALL RACER

The Air Hogs

Zero Gravity Micro

Wall Racer

defies gravity with its wall climbing ability!

Featuring a suction throttle, that allows the

wall racer to perform full function while climbing

walls. FOR INDOOR USE ONLY.

ADULT SUPERVISION RECOMMENDED!

ROBLEMS!

efore you return to retailer,

lease call our HOTLINE for assistance,

1-800-622-8339

TO GET THE MOST OUT OF

YOUR ZERO GRAVITY MICRO™

WALL RACER PLEASE READ

THESE INSTRUCTIONS FIRST !

NOTE: USE ON SMOOTH, CLEAN

SURFACES ONLY!

Check to make sure contents are

complete:

• 1 Radio-Controlled Zero Gravity

Micro™ Wall Racer

• 1 Controller/Charger

Left

Joystick

Right

Joystick

NSTRUCTIONS

AH Zero Gravity Micro™

Wall Racer

Controller/Charger

CAUTION – ELECTRICALLY OPERATED

PRODUCT: Not recommended for

children under 8 years of age. As with

all electric products, precautions

should be observed during handling

and use to prevent electric shock.

BATTERY INSTALLATION

1. Loosen screw and remove the battery

compartment door.

2. Install six 1.5-V alkaline batteries (not

included) in the battery compartment

as shown.

Make sure to follow the

correct positive (+) and negative (-)

polarities with the corresponding

markings inside the battery compartment.

3. Re-install the battery compartment door

and tighten the hold down screw.

Contr

oller/Char

Battery

Compar

tment

Door

Six

1.5-V

Alkaline

Batteries

Your Zero Gravity Micro™ Wall Racer

has pre-installed rechargeable battery

inside the vehicle body.

Batter

Compar

tment

CHARGING YOUR ZERO GRAVITY MICRO™ WALL RACER

1. Make sure the vehicles

ON/OFF switch is in the

“OFF” position. The

Zero Gravity Micro™ can

only be charged when

the vehicle is in the

“OFF” position.

3. Access

the charge

cable.

4. Plug the

charging

cable into

the port in

the back of

the vehicle.

Make sure

the arrow is

on top.

6. The green charging

light will begin to

flash. When the green

light turns OFF, the

vehicle is fully

charged.

• Charging should take between 20 and 40 minutes depending on how much

charge is left in the battery. •

NOTE: Do not charge the battery immediately

after use. Let the battery cool for at least 10 minutes. If charging is not

complete after a long period of time, replace the charger batteries.

2. Make sure

the controller/

charger switch

is in the “OFF”

position.

5. Slide the

switch on the

controller/

charger to the

CHARGE

position.

7. When charging

is complete, tur

the controller/

charger s

witch

to the

“

OFF”

position.

8. Store the

charge cable in

the storage

compar

tment.

1. Stand at least 4’

from the wall.

nly drive

n empty walls,

(

no hanging

ictures or

ther obstacles)

nd avoid driving

n walls that have

nything underneath

hem. The Zero Gravity Micro™ could

et damaged if it were to fall.

Note: Use only on smooth, clean

surfaces and clean the tires with a

damp rag before each use. Do not run

on damp surfaces.

3. DO NOT drive over wall

sockets, light switches or

other obstructions.

o not drive to or off the

dge of the wall.

4’

IMPORTANT:

The Zero Gravity

Micro™ Wall Racer has

working headlights.

When the headlights begin to blink,

the rechargeable battery is running

low on power and should be removed

from the wall immediately. Otherwise

the vehicle will fall off the wall.

2. To drive on the walls

you must put the vehicle

in the WALL mode. To

do that, move the power

switch at the back of the

vehicle all the way to the

LEFT.

1. Turn the

controller/charger

“ON”.

IMPORTANT:

Before turning controller

ON, make sure that both

joysticks are in the neutral

(middle) position.

4. The fabric air skirts

can be adjusted outward

at a 45° angle to

ensure a proper vehicle

air suction to the wall.

HILE DRIVING YOUR ZERO GRAVITY MICRO™ WALL RACER, MAKE SURE TO OBEY THESE RULES

DRIVING ON WALLS

neutral positions

Fabric

air skir

3. Place the

vehicle on the wall

as shown.

5. Avoid driving on the ceiling when other people are around.

6. Do not stand underneath when driving on the ceiling. 7. Never get alcohol on the fabric air skirt.

IMPORTANT:

The Zero Gravity Micro™ Wall Racer should be driven only on a smooth,

clean, flat surface. Dirt or debris can get inside the fan and cause damage.

To drive on the ground, place the vehicle power switch to the middle

(ground) position. The fan

will not turn ON, but the vehicle will drive full

function on the ground. (The ground mode saves the battery charge).

Keep Zero Gravity Micro™ away from hair.

USING THE CONTROLLER

DRIVING ON THE GROUND

FORWARD

REVERSE

EFT TURN

RIGHT TURN

TRIM

ADJUSTMENT

If the vehicle is not driving straight you

can use the trim adjusters.

2. If the vehicle

turns to the

LEFT, press

the Right trim

button until it

drives straight.

1. Set the v

ehicle in

OUND

mode and using the Controller

drive the vehicle

FORWARD.

WHEN FINISHED PLAYING WITH YOUR ZERO GRAVITY MICRO™ WALL RACER

When finished playing with

our Zer

o Gra

vity Micro™

all Racer:

. Turn the controller OFF.

2. Remove vehicle from wall.

3. Turn vehicle OFF.

TE:

void cleaning the

all Racer with alcohol.

1 32

3. If the vehicle

turns to the

RIGHT, press

the Left trim

button until it

drives straight.

The LEFT joystick controls the

vehicle Forward and Reverse.

ush the LEFT joystick forward

nd the RIGHT joystick left or

ight to control the vehicles’

irection.

IMPOR

TANT BATTERY INFORMATION:

• Do not mix old and new batteries.

• Do not mix alkaline, standard or rechargeable

batter

ies.

• Battery installation should be performed by an adult.

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the

toy before being charged (if removable).

• Rechargeable batteries are only to be charged under

adult supervision.

• Only batteries of the same or equivalent type as

recommended are to be used.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the toy.

• The supply terminals are not to be short circuited.

• Different types of batteries, or new and used

batteries are not to be mixed.

• Exhausted batteries are to be removed, as they will

adversely affect the performance.

Your Zero Gravity Micro™ is equipped with a Lithium Polymer battery.

WARNING:

• Do not lea

ve the toy unattended while charging it.

• Batter

y charging should be done b

y adults

• Charge the toy on a non-flammable surface and keep it away from flammable items.

•

Do not expose battery to direct sunlight. There is a risk of the battery exploding, overheating,

or igniting.

• Do not disassemble, modify, heat, or short circuit the battery.

• Do not place batter

y in fires or leave in hot places.

• Do not drop or subject to strong impacts

• Do not allow the battery to get wet.

• Only charge the batter

y with the specified Air Hogs

batter

y charger.

• Only use the batter

y in the de

vice specified b

y Air Hogs

• Turn the charger off when the toy’s battery is charged, and always unplug it from the toy.

• Disconnect AC wall chargers from outlets while not in use.

•

If the to

y has been damaged, immediately stop use

, unplug, and saf

ely move the toy away from

flammable materials.

• Follow the manufacturer’s instructions for charging the toy. Do not charge longer than recommended.

• Carefully read the instr

uction man

ual and use the batter

y correctly

RIGHT SPIN

By pushing the joystick on the controller/charger, you can make your Wall Racer spin around on the spot.

Push the RIGHT joystick to the right

to make the vehicle spin clockwise.

Push the RIGHT joystick to

the left make the vehicle spin

counter-clockwise.

LEFT SPIN

SPINS

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures :

• Reorient or relocated the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

TROUBLESHOOTING

FCC REQUIREMENTS

Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada

Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,

Williamsville

, NY 14221, USA

Spin Master

Toys Far East Limited. Rm #1113, 11/F, Chinachem Golden

Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK

Spin Master Toys UK Ltd., Meadowbank, Furlong Road, Bourne End, Bucks,

SL8 5AJ, United Kingdom

Spin Master France – 36 rue de Silly – 92100 Boulogne Billancourt – France

North American Consumer Information

Phone: 1-800-622-8339

www

.spinmaster

.com

registered trademark of Spin Master Ltd. All rights

reserved. Conforms to product safety standards

ASTM F963, regulator

y requirements

Products

and colors may vary. Please retain this information

for future reference. Patent Pending.

MADE IN CHINA.

Asst. #44317 NEN REV 0

PROBLEM

ehicle will not start.

Vehicle does not climb.

Vehicle does not drive straight.

Vehicle slips climbing the walls.

Vehicle falls off the wall.

Vehicle will not climb walls.

SOLUTION

1. Power switch is off. Turn on. 2. Controller battery is installed with incorrect polarity. Check the

(+) and (-) markings to make sure the battery is properly aligned. 3. Batteries are drained.

Charge batteries and/or install new batteries.

Over current protection is engaged. Turn vehicle off for 30 seconds then restart.

1. Make sure surface is clean of dirt/dust. 2. Make sure surface is neither too rough or too

smooth. 3. Make sure surface is flat.

1. Clean the tires with a damp rag. 2. Fold up the fabric skirts for a better seal prior to use.

1. Make sure to discharge and then charge again for 20 to 40 minutes. 2. Clean tires and make

sure your wall and floor are also clean. 3. Check the fabric skirts for damage. If they have been

pulled loose, tape them back on with flexible tape. 4. Make sure surface is flat.

1. Suction jammed.

CALL 1-800-622-8339.

Contains LiPo battery

pack. Batter

y pack

must be recycled or

disposed of properly

This Class B digital appar

atus complies with Canadian ICES-003.

Spin Master Air Hogs Zero Gravity Micro Wall Racer Operating instructions

Spin Master Air Hogs Zero Gravity Micro Wall Racer Operating instructions

Spin Master Air Hogs Zero Gravity Micro Wall Racer Operating instructions

Related papers

Other documents