2. Minka Group
  3. P5510-706-L

Minka Group P5510-706-L User manual

  • Hello! I've reviewed the Installation Instructions for the american lighting P5510-706 light fixture. This document provides step-by-step guidance on mounting the fixture, connecting the wires, and installing the bulbs and glass. It also highlights key safety precautions, such as shutting off power before installation. I'm here to help you with any questions you might have about installing this product.
  • What should I do before starting the installation?
    How do I attach the mounting plate?
    What type of bulbs does this fixture use?
    What should I do after connecting the wires
INSTALLATION INSTRUCTIONS
Item#P5510-706 (New. 2023/02/20)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the fuse box or circuit breaker box
and remove the old fixture including the mounting
hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Attach mounting plate (A) using the mounting
screws (B) (Size: #8-32N*L0.5”) to the junction box.
The side of mounting plate (A) marked “GND” must
face out.
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If
your junction box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the mounting plate (A) using the green screw
provided. After wires are connected, tuck them
carefully inside the junction box.
FINISHING THE INSTALLATION (Fig.1)
5. Place fixture body (D) over mounting plate (A) and
secure with screws (C).
6. Install (5) five G9 base bulbs (F) up to 2 watts LED
bulbs (included) in accordance with the fixture
specification—DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!). Do Not
Use SBLED Lamp Marked – Not For Use In
Totally Enclosed Luminaires.
7. Place glass (G) over socket (E) and twist to secure.
Your installation is now complete. Return power and
test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
LA-3640E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set
#
-
02
1
-
118D
H
-Mounting plate
-Ground screw
-Mounting screw*2
A
B
C
D
E
F
G
/