File:fe340-h1-par-45.doc
Meitav-tec Ltd. (Contel group), 6 Sapir street, New Industrial Zone P.O.B 5221 Rishon-Lezion, 75150, Israel
T
l: +
72-
-
2
4
2
F
x: +
72-
-
2
2
W
: www.m
i
v
.
m
E-m
il:
r
m
i
v
.
m
FE-340-H1-PAR-45 - Operating manual
1. Turnning the unit ON
• Press the ON button to turn the unit ON – “ON” will appear on display.
2. Turnning the unit OFF
• Press the OFF button to turn the unit OFF – “OFF” will appear on display.
3. Setting temperature
• Press the (+) or (-) buttons – the set-point temperature will appear on display.
• Adjust the set-point temperature using the (+) or (-) buttons.
4. Technician settings – offsetr for temperature readings calibration and protective high limit
for heating.
• Press and hold the empty button (without text) for 20 seconds until the offset - a number
betwee -6…+6 appears on display.
• Adjust the offset temperature using the (+) or (-) buttons. The offset is used for calibration of
the measured temperature when needed.
• Press the empty button again – 44, 45 or 46 will appear on display.
• Using the (+) and (-) buttons adjust the protective high limit for heating. When the temperature
reaches the limit, the heat element will stop.
• Press the empty button again to return to normal display.
ON
OFF
O
C
ON
SET
OFFHeat