Scotsman KBILC Basic Ice Level Control Instructions 17-3827-01 Operating instructions

Hello! I've reviewed the instructions for the Basic Ice Level Control Kit (KBILC). This document outlines the installation process, from disconnecting power to adjusting the ice level. I understand the details about sensor mounting, wire routing and connections. I am ready to answer your questions about the installation and use of this kit.
How do I lower the ice level?

How do I raise the ice level?

Where should the sensor be kept for dispenser applications?

Installation:

1. Depress and hold the O button until the machine shuts O (Status light will go out).

2. Disconnect power to machine at wall or at breaker.

3. Remove front panel.

4. Locate sensor mounting hole in base of machine. The hole is located towards the back of the ma-

chine and has a foam plug in it. Remove the plug. Wipe area around plug to remove dust and dirt.

5. Position sensor in hole and press into place. Be sure sensor mount ts tight against the sheet

metal.

6. Open control box door.

7. Route the sensor wire through the control box snap bushings.

Note: Route connecting wire away from items like the fan blade, discharge tubing and

crankcase heater.

8. Connect ice level control to control board at J13

9. Close control box door. Secure with original screw.

10. Adjust ice level control to desired level. To lower ice level, pull sensor down from inside bin or

dispenser. To raise ice level, pull sensor up from inside ice machine while holding sensor mount

down.

Note: Do not pull on sensor wire to adjust ice level, only sensor body/exible tubing.

For dispenser applications, keep sensor above agitator arm to avoid damage.

11. Reinstall front panel.

12. Reconnect power to machine.

13. Push and release the ON button to resume ice making.

INSTRUCTIONS

Basic Ice Level Control Kit (KBILC)

17-3827-01

Foam Plug in Sensor Location Connect to control board at J13