GROHE 33 122 Instructions Manual

Brand: GROHE

Model: 33 122

Type: Instructions Manual

.....1

.....5

.....9

.....13

.....17

.....21

.....25

.....2

.....6

FIN

.....10

.....14

.....18

EST

.....22

.....26

.....3

.....7

.....11

.....15

SLO

.....19

.....23

RUS .....27

.....4

.....8

UAE

.....12

.....16

.....20

.....24

Design & Quality Engineering GROHE Germany

95.374.231/ÄM 214955/06.09

33 122 33 124

.....1

.....5

.....9

.....13

.....17

.....21

.....25

.....2

.....6

FIN

.....10

.....14

RUS

.....18

EST

.....22

.....26

.....3

.....7

.....11

.....15

.....19

.....23

RUS .....27

.....4

.....8

UAE

.....12

.....16

.....20

.....24

Please pass these instructions on to the end user of the fitting.

S.v.p remettre cette instruction à l'utilisateur de la robinetterie!

Bitte diese Anleitung an den Benutzer der Armatur weitergeben!

33 122

33 124

Application

Can be used in conjunction with: Pressurised storage

heaters, thermally and hydraulically controlled

instantaneous heaters. Operation with low-pressure

displacement water heaters is not possible.

Specifications

• Flow pressure min. 0.5 bar / recommended 1 - 5 bar

• Operating pressure max. 10 bar

• Test pressure 16 bar

If static pressure is greater than 5 bar, fit pressure

reducer.

Avoid major pressure differences between hot and

cold water supply.

• Flow rate at 3 bar flow pressure: approx. 8 l/min

• Temperature

Hot water inlet max. 80 °C

Recommended (energy saving) 60 °C

• Water connection hot - left

cold - right

Installation

Flush piping system prior and after installation of

fitting thoroughly (Consider EN 806)!

Installation and connection, see fold-out page III,

Fig. [1].

When assembling, the waste rod (A) has to be placed

into the body.

Fit pop-up waste set (28 915), see fold-out page II.

Seal plug-hole rim!

Open cold and hot-water supply and check con-

nections for leakage!

Check fitting for correct operation, see fold-out

page III, Fig. [2].

Temperature limiter

On delivery, the temperature limiter (fitted as standard)

is inoperative.

For commissioning see “Replacing the cartridge”

point 1 to 4.

Remove temperature limiter (B) and, depending on the

maximum temperature required, turn clockwise (to

increase temperature) or anticlockwise (to reduce

temperature) and refit, see Fig. [3] and [4].

Flow rate limiter

This fitting is fitted with a flow rate limiter, permitting an

infinitely individual variable reduction in the flow rate.

The highest possible flow rate is set by the factory

before despatch.

The use of flow rate limiters in combination with

hydraulic instantaneous water heaters is not

recommended.

For commissioning see “Replacing the cartridge” point

1 to 5, Figs. [3] and [5].

Maintenance

Inspect and clean all parts, replace as necessary and

grease with special grease.

Shut off the hot and cold water supply!

I. Replacing the cartridge, see Fig. [3].

1. Lever out plug (C).

2. Remove set screw (D) using a 3mm socket spanner

and pull off lever (E).

3. Release screw (F) and pull off collar (G).

4. Unscrew cap (H).

5. Pull off temperature limiter (B).

6. Remove screws (I) and detach complete

cartridge (J).

7. Change complete cartridge (J).

Assemble in reverse order.

Caution

In this process, note the relative positions of the

collar (G) and lever (E). The lugs (K) on the collar (G)

must engage the central recesses (L) in the lever (E),

see Fig. [6].

Make sure that the cartridge seals engage in the

grooves on the housing. Fit screws (I) and tighten

evenly and alternately.

II. Unscrew and clean flow straightener (13 960), see

fold-out page II.

Assemble in reverse order.

Replacement parts, see fold-out page II ( * = special

accessories).

Care

For directions on the care of this fitting, refer to the

accompanying Care Instructions.

III

13mm

3mm

GROHE 33 122 Instructions Manual

Brand: GROHE

Model: 33 122

Type: Instructions Manual

Download PDF

report

in other languages

français: GROHE 33 122

GROHE 33 122 Instructions Manual

GROHE 33 122 Instructions Manual

in other languages

Related papers