2. Polaris
  3. Ranger
Ranger

Polaris Ranger User manual

  • I have reviewed the provided installation instructions for the Battle Armor Rear Bumper designed for Polaris Ranger models. The document outlines steps for removing the tailgate, securing the bumper with existing and supplied hardware, and emphasizes to torque to factory specs. I am ready to assist you with any questions you might have.
  • What size bolts are used to initially secure the bumper?
    Should the initial bolts be fully tightened right away?
    Should all hardware be tightened once installed?
Polaris Ranger Gen 2 Rear Bumper Installation Instructions
Fitment:
-13-17 Ranger 1000
-13-18 Ranger 900
Part #: 200-1107-G2
1) Remove tailgate to access the outer 10mm bolts on each side behind tailgate.
2) With bolts removed hold bumper into place and secure reusing the 10mm bolts. Leave
bolts loose until all hardware is in.
3) Using the supplied hardware secure bumper to frame and tighten all hardware.
Installation is complete
Note: torque to factory specs
/