2. Wasp
  3. dr5
dr5

Wasp dr5 Owner's manual

  • Hello! I've read the user guide for the DR5 Gun Grip. This document provides instructions for assembling and disassembling the gun grip with the DR5 device. It also stresses the importance of using bumpers on the DR5 and the recommended 6000mAh battery. I am ready to answer any questions you have based on the information in this guide.
  • What should I do if something is missing from the box?
    Is it required to have bumpers on DR5 device to use it with the gun grip?
    What battery is recommended to use with the DR5 gun grip?
    How to assemble DR5 device to this gun grip?
    How to disassemble DR5 device from this gun grip?
DR5 Standard Gun Grip
Package
Please make sure the following contents are in the
gun grip box. If something is missing or damaged,
please contact your Wasp representative.
• DR5 standard gun grip
• Wrist Strap
• Quick Start Guide
Note:
• The gun grip is only applicable to the DR5 with the
bumpers on.
• It is strongly recommended to use the DR5 with
the 6000mAh battery.
Quick Start Guide
V1.0
Assemble with DR5:
1. Place the 2 top corners of the DR5
into the top of the gun grip.
2. Press the bottom of the DR5 into the gun grip.
3. Ensure 2 top corners and 2 hooks of gun grip fit
securely with the DR5.
Step 1
Step 2
Disassembly from DR5:
Slightly pull the 2 hooks of the gun grip and lift
the bottom of the device to remove from the gun grip.
For more information about Wasp products, visit
www.waspbarcode.com.
Caution!
To ensure the unit is working properly, please keep all connectors
away from contaminants such as dust, grease, mud, and water.
Negligence may cause the unit to short circuit, overheat or
may prevent it from communicating.
If the connector is damaged, please ensure the connector is
fully repaired before using the unit to avoid causing the device to
short circuit.
/