Rev 7-21 2452469
Place label here
Winegard® Extreme™ 2.0 Outdoor WiFi Extender Quick Start Guide
For more product details, including full manual,
warranty, and videos visit Winegard’s website.
SETUP
1SCAN for wireless networks using a WiFi-
enabled device
(tablet, smartphone, or laptop)
.
To speed up installation, turn off Auto-Join (Apple) or
Auto-Connect (Android) on the WiFi service you intend
to join.
2SELECT SSID and connect with password on
label below.
Allow up to two minutes for the SSID to appear as an
available selection.
3OPEN an internet browser once connected, and
type 10.11.12.1 into the address bar. Press Enter.
Login information
Username: admin Password: admin
Click Scan for WiFi. Select desired 2.4 GHz
Local Network.
Signal strength below 50% is not recommended.
Click Continue. Enter network password if
prompted. The unit will reboot and you may need
to reconnect to the internet. Once connected
(takes up to two minutes), the strength of your
connection will appear under WiFi Signal.
4READY for expanded internet!
Check out the complete manual on our website
for additional features. It covers setting up
access point wired mode or bridge mode,
changing your password or SSID, enabling a
5GHz network, and more. Setup videos are also
available on our website.
Recommended browsers: Microsoft® Edge, Firefox®, Google Chrome™, or Safari®
Winegard Company 2736 Mt. Pleasant St. | Burlington, IA 52601
Printed in U.S.A. © 2021 Winegard Company
All trademarks, registered trademarks, and logos are the property of their respective owners and are not affiliated with Winegard Company.
PERFORM INSTALLATION BEFORE CONTINUING
WITH SETUP BELOW