WINGBO WBWL-GL15-CH User manual

WARNING:

.Check for electric, gas, & plumbing lines before drilling or consult a professional.

.Turn off your electricity at the circuit breaker or main fuse box before installation. Do not restore power to

the line until the light has been fully installed.

.Do not use with bulbs exceeding the recommended wattage.

.Always switch off the electricity supply and allow bulbs to cool for 10 minutes before changing.

ASSEMBLY INSTRUCTIONS

This fixture has been rated for up to one (1) E26 Socket 60-Watt maximum light bulbs or LED equivalent

bulbs (not included).

To avoid the risk of fire, DO NOT EXCEED THE RECOMMENDED LAMP WATTAGE.

The lighting fixture is meant for indoor use.

ASSEMBLY

Please follow the steps (1-6) to install the lighting fixture.

1. To reduce the risk of electric shock, ensure electricity has been turned off at the circuit

breaker or fuse box before beginning.

2.Take the wall bracket off the canopy connect your wall bracket to your junction box(not included) using

the provided screws.

3. Make electrical connections using the wire nuts.

4. Being careful that no wiring is left exposed, place the canopy against the mounting surface.

Secure the canopy to the wall bracket with the 2 previously removed ball nuts.

5. Install the shade to the socket.

6.Install the light bulbs (not included).

Thanks for your purchase!

Should you have any questions or concerns, please do not hesitate to contact us by mail address

support@wingbolighting.com