Look at the diagrams
Use either the 3.5mm jack plug or the single Brown wire in pin locations 1,2 & 3
Use the link leads to suit the type of head unit you are fitting.
Carefully lift the latch on the plastic housing to remove a link lead
WHEN FINISHED ALWAYS PLUG THE PATCH LEAD TO THE CONTROL BOX FIRST,
BEFORE YOU CONNECT THE CAR HARNESS TO THE POWER
29-025 – Self pin universal patch lead
29-025 – Self pin universal patch lead
Look at the diagrams
Use either the 3.5mm jack plug or the single Brown wire in pin locations 1,2 & 3
Use the link leads to suit the type of head unit you are fitting.
Carefully lift the latch on the plastic housing to remove a link lead
WHEN FINISHED ALWAYS PLUG THE PATCH LEAD TO THE CONTROL BOX FIRST,
BEFORE YOU CONNECT THE CAR HARNESS TO THE POWER
Make sure the terminals are
inserted the correct way
around.
Terminal orientation for top
row
Terminal orientation for
bottom row
Make sure the terminals are
fully inserted.
If the terminal is still visible
from the wire entry side of
the connector, it is not fully
inserted.
The terminal should be
visible looking from above/
below the connector.
Make sure the terminals are
inserted the correct way
around.
Terminal orientation for top
row
Terminal orientation for
bottom row
Make sure the terminals are
fully inserted.
If the terminal is still visible
from the wire entry side of
the connector, it is not fully
inserted.
The terminal should be
visible looking from above/
below the connector.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Medtronic LIFEPAK 12 User manual
-
Sharp 300-732WH User manual
-
Avaya CMC1 User manual
-
Xantech MRAUDIO8X8 Feature Descriptions
-
Campbell Scientific MetData1 Owner's manual
-
Lucent Technologies Release 6 User manual
-
Evinrude E-tec 90 HP User manual
-
Chrysler Intrepid User manual
-
Buell 2007 FIREBOLT User manual
-