Vixen Horns VXA7200L Owner's manual

VXA7200L

INSTALLATION GUIDE

PAGE 1 of 2

BEFORE BEGINNING YOUR INSTALLATION

Read through the instruction guide before getting started with the installation. Professional installation is recommended for

this product.

CONTENTS

 170-200 PSI Pressure Switch (1/4" NPT)

 Water-proof Cover with 10 gauge Wire Leads

SAFETY INSTRUCTIONS

 Make sure your battery ground is detached before getting your installation started.

 Employ equipment for eye protection during drilling operations.

 Ensure that your air system has no pressure before starting the installation.

The specific voltage requirement for this pressure switch is 12 or 24 volt DC, therefore installation must be done

to a DC power source of 12 or 24 volts.

PRESSURE RATING

 Pressure Switch has a rating of 170 PSI ON, 200 PSI OFF. When the air pressure in the air tank is below the

preset ON pressure (170 PSI), the compressor will automatically turn on and will start pumping air into the

tank. When the pressure reaches the cut OFF pressure (200 PSI), the compressor will be automatically shut

off.

VXA7200L

INSTALLATION GUIDE

PAGE 2 of 2

MOUNTING

 Apply thread sealant to pressure switch's threads and install it on one 1/4" NPT port available in the Air Tank.

DO NOT OVER TIGHTEN.

 Inspect the connection for leaks with a mixture of soap and water.

 IMPORTANT: For better performance, never install the pressure switch in a port facing the intake port of the

air tank. Best options are a port that is on the same side or perpendicular to the intake port.

WIRING

 Connect the black wire (negative) of the compressor to any of the Pressure Switch’s terminals.

 The remaining Pressure Switch terminal should be connected to ground; secure the end under any metal

body bolt or to the negative side of the vehicle’s battery. Be sure that the ground connection is rust and paint

free.