1 Shot 1S-CDS User manual

1S-CDS Concrete Sealant: Use and Care Instructions:

1 Shot concrete sealant is engineered to form an extremely strong bond to all stone and brick surfaces.

Surface Preparation: Clean and dry all intended surfaces before using. For best performance insure

that surfaces are free of dirt, oils, waxes, mold and mildew and loose flaking paint. Mineral spirits or

acetone can be used to rid the surface of residue. Lightly sand the surface with steel wool to remove

loose or flaking paint.

Application: DO NOT THIN. Stir product before and during use. Apply with a synthetic brush, ¼”-3/8”

nap roller or an airless sprayer. For proper adhesion, apply product at air and surface temperatures

between 50-90F (10-32C) and for exterior surfaces, when precipitation is not forecast for 24 hours. If

applying from multiple containers, mix all containers together and stir well to insure a uniform

appearance.

Dry Time: Allow up to 4 hours for product to dry to the touch. Longer dry times may result if product is

applied in cold or humid conditions. Allow at least 2 weeks before washing surface with any sort of

detergent or pressurized washer.

Cleanup: Rinse all brushes, rollers and sprayer tips with warm water and a mild detergent. Properly

dispose of soiled rags, and store product away from freezing temperatures and direct sunlight. Dispose

of excess product at a proper disposal facility. Please do not dump in drains that lead to streams or

natural water sources.

WARNING! IRRITANT! HARMFUL IF SWALLED. MAY CAUSE EYE, NOSE, AND THROAT IRRITATION.

AVOID CONTACT WITH SKIN AND EYES AND AVOID BREATHING VAPORS AND SPRAY MIST. WEAR EYE

PROTECTION AND PROTECTIVE CLOTHING. USE ONLY OUTDOORS OR IN A WELL VENTILATED AREA.

To avoid overexposure, open windows and doors or use other means to insure fresh air entry during

application. If you experience eye watering, headaches, or dizziness increase fresh air, wear, respiratory

protection (NIOSH approved for organic vapor, obtain professional advice before using), or leave the

area. Avoid contact with eyes and skin. Wash thoroughly after handling. Keep container tightly closed.

Do not expose to temperatures exceeding 122F (50C)

First Aid: If experiencing respiratory symptoms: Remove person to fresh air and keep comfortable for

breathing. If respiratory symptoms persist get medical attention. If in eyes: Flush immediately with

plenty of water for at least 20 minutes and get medical attention. Remove contact lenses if present and

continue flushing with water. If on skin: Wash with plenty of soap and water. If skin irritation or a rash

occurs, get medical attention. If swallowed: Do NOT induce vomiting. Get immediate medical

attention. Poison Control Center: 1-800-222-1222

Download PDF