2. SunBriteTV
  3. SB-V-43-4KHDR-BL

SunBriteTV SB-V-43-4KHDR-BL, SB-V-55-4KHDR-BL, SB-V-65-4KHDR-BL, SB-V-75-4KHDR-BL Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the SunBriteTV SB-V-43-4KHDR-BL Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Veranda Outdoor Television
Quick Start Guide: SB-V-43-4KHDR-BL, SB-V-55-4KHDR-BL,
SB-V-65-4KHDR-BL, SB-V-75-4KHDR-BL
Planning the Location
Veranda Series TVs are completely
weatherproof. For best viewing, please install
in a shaded environment.
Sources/What to Watch
• Signals can be sent from any source using
an HDMI, Component, or Digital Antenna
connection and corresponding cables.
• To attach a SunBrite sound bar (purchased
separately), use the proprietary cable
included with the sound bar.
• Refer to the operator’s manual for detailed
instructions on cable connections.
Cable Management
Speaker
Bar
SBTV PN:L21-001-00
HDMI 3 HDMI 2
ARC
HDMI 1
PC/VGA
RJ45
Control
RL
RLPrPbY
SBTV PN:L21-001-00
USB 3.0
[DC 5V 900mA]
ATSC/NTSC
Tuner
Analog
Audio Out
Component
Video
Composite
PC/VGA
Audio In
Rear IR
Receiver
Digital Audio Out
SPDIF
SPEAKER BAR OUTPUT
(Requires adapter
included with SunBrite
soundbars)
ETHERNET
(RJ 45 for
IP Control)
HDMI 3 HDMI 2
ARC
HDMI 1 PC/VGA
VIDEO IN
PC/VGA
AUDIO
IN
COMPONENT
AUDIO &
VIDEO IN
DIGITAL
AUDIO OUT
CABLE
ANTENNA IN
USB
REAR IR
ANALOG
AUDIO OUT
• After all connections are made, all wires
must exit the media bay from the bottom.
• Up to 5 cables can exit the media bay
while still maintaining the integrity of the
weatherproof door seal.
Note: Leave a drip loop as the wires enter the
compartment.
• Tighten the thumb screws completely to
weatherproof the TV.
Wires
Drip Loop
Media Bay
Thumb Screws
SETUP
• Use the TV remote to access the setup menu and run initial installation.
• Select Antenna or Cable then enter to continue. If you are using antenna or cable click
start to learn the channels, otherwise select skip. Select Exit Setup to nish.
• Refer to the operator’s manual for detailed instructions. Press “Menu” on the remote
control to access the internal operation manual or visit the product support page on
www.snapav.com or www.sunbritetv.com.
CONTROL
The Veranda can be controlled via the included remote or universal remote.
IR codes are available at: https://www.sunbritetv.com/support/product-support/product-faq.
© 2018 SunBriteTV Rev:181126-1115
DOC-052-00
/