Mounting shims (4)
1/4-20 x 0.75” screws (2)
9/64” Allen wrench
3/16” Allen wrench
Supported VESA patterns
Product weight
Shipping weight
Bracket material
200 - 600 mm × 200 - 400 mm
10 lb / 4.5 kg
15 lb / 6.8 kg
3 mm P&O steel
SPECIFICATIONS
DIMENSIONS - Soundbar TV Bracket
Deep paddles (2, attached)
Shallow paddles (2)
VESA 200 - 400 mm
VESA 200 - 600 mm
22 15/16"
[58.2 cm]
5 7/16"
[13.7 cm]
INSTALLATION
1
Install the EZ Mount posts and
knobs supplied with the soundbar.
(If soundbar has 4 holes, use the
two center holes as shown.)
2
Shallow option: Soundbar is
thinner than thickest part of TV
Deep option: Soundbar is thicker
than thickest part of TV
4
Shallow only—Swap lower section of soundbar bracket over to shallow paddles.
TRIAD INSTALLATION GUIDE - SOUNDBAR TV BRACKET
WARRANTY
Soundbar bracket assemblies (2)
Limited Hardware Warranty—Triad Speakers warrants its hardware product to be free
from defects in material and workmanship during the warranty period. If the hardware
proves to be defective in material or workmanship during the warranty period, Triad
Speakers will, at its sole option, repair or replace the product with a like product. The
warranty extends only to products purchased directly from Control4 Corporation or
an Authorized Control4 Dealer. For complete limited warranty information, including
details on purchaser legal rights as well as limited warranty exclusions, visit
http://triadspkrs.co/warranty.
Return Merchandise Authorization (RMA) information
For Sales RMAs contact your Inside Sales Associate. Your ISA information can be
found in the My Account section of the Dealer Portal under Control4 Contacts.
Technical Support information
Phone: 503-517-2668
Hours: 9:00 a.m. – 5:30 p.m. PST (Monday – Friday)
Email: service@triadspeakers.com
DEEP DEEP
DEEP
Decide if you need the deep paddles or the shallow paddles. The bracket is
shipped with the deep paddles installed.
Lay TV and soundbar “face down”
on a protected work surface.
INTRODUCTION
The Triad TS-BKT-SBTV Soundbar TV Bracket is designed to attach a Triad Micro
or Mini Soundbar to a flat-panel TV that is mounted to a wall with a VESA-
compliant articulating (full-motion) wall mount. The TS-BKT-SBTV allows the
soundbar to be positioned directly below the TV and move "as one" with the
movement of the TV. The TS-BKT-SBTV also allows for the soundbar to be
adjusted (forward, backward, left, and right) so that the front of the soundbar is
flush and in-line with the front edge of the flat-panel TV.
IN THE BOX
NOTICE / CAUTIONS
Important: The TS-BKT-SBTV has been designed to hold and support the weight of
Triad's largest and heaviest soundbars. This bracket should only be used with
articulating TV wall mounts that have met a third-party safety certification
(example: UL Certified).
Important: The TS-BKT-SBTV physically attaches between the TV and the TV
wall-mount bracket. Carefully check the TV mount's manual for maximum weight
allowed / recommended. Add up the weights of all items: TV + Soundbar +
TS-BKT-SBTV and confirm before proceeding with the use of this bracket.
Warning! Pinch points—There are moving / hinged parts on the
TS-BKT-SBTV that can cause a pinch while installing. These will be
called out in this manual with the following indication:
2
1
2
3
a
Remove the nut on the end of the
bar using the provided wrench.
b
Loosen the nuts on the paddle if
needed.
c
Remove the deep paddle from the
rest of the bracket.
d
Loosen the nuts on the shallow
paddle if needed.
e
Add the shallow paddle onto the
bar.
f
Secure the deep paddle by replace
the nut on the end of the bar and
tightening the nuts.
a
b
c
d
e
f
7/16” open-end wrench
Mounting shim dimensions
40 × 80 × 8 mm
SUPPORTED MODELS
Model number
Supported soundbar models
Triad Soundbar TV Bracket, TS-BKT-SBTV
All full-size Triad Micro and Mini Soundbars
Supported TV mounts Most articulating (full-motion) UL-certified mounts
DEEP DEEP
SHALLOW SHALLOW
DEEP
Deep option
Note: To move the TV and soundbar on the articulating mount after installation is complete, grasp the TV with
a hand on both the left and right sides and pull or push on the TV to move both the TV and the soundbar.
Do not pull or push on just the soundbar.
or
SHALLOW
DEEP
INSTALLATION, cont.
6
7
Using the accessories package and instructions supplied with the
TV wall-mount bracket, choose the appropriate mounting bolts needed
to attach both the TV wall-mount bracket and the Soundbar TV Bracket
to the back of the TV. Carefully follow the TV wall-mount bracket instructions
to determine the correct length of the bolts needed.
5
Place soundbar bracket assemblies with the shallow or deep paddles attached
on the back of your TV. Line the vertical brackets up with the VESA mounting
holes on the back of your TV.
DEEP
DEEP
Mounting
shims (4)
Firmly press the soundbar grill onto the soundbar.
Push binding posts down to align wire holes and insert wire.
Release binding post top when wire has been inserted.
INSTALLATION, cont.
8
Use two 1/4-20 x 0.75 screws (included in this kit) to attach the paddles to
the back of the two EZ Mount posts previously installed on the soundbar
in Step 1.
Note: Do not block the speaker terminal connections with the paddle.
1/4-20 x 0.75
Allen head screw (2)
Shallow optionDeep option
TTighten all hardware in the following order: (a) rails, (b) paddles,
(c) others
9
10
TRIAD INSTALLATION GUIDE - SOUNDBAR TV BRACKET
www.control4.com | 1-888-400-4072 | 200-00598-A 2019-7-09 DH
VESA mounting holes
Add your TV wall-mount brackets. The
soundbar bracket rails are designed so
that most wall-mount brackets will fit
inside the rails.
Side view
Optional: If your TV mounting rails do not fit inside the
soundbar bracket rails (or your TV mount is the flat
plate style), add mounting shims between the brackets
to give a solid / flat mounting surface for the TV mount.
Using two people, carefully lift the TV and soundbar—supporting both products—and complete the attachment to the wall mount. Final adjustments (centering /
leveling to the TV) can be done by adjusting the EZ mount knobs.
Finish the installation by attaching the soundbar speaker grill and connecting the speaker wire(s).
DEEP
SHALLOW
Shallow option
11
Copyright © 2019, Control4 Corporation. All rights reserved. Control4, Pakedge, Triad and their logos are registered trademarks or trademarks of Control4 Corporation in the United States and/or
other countries. 4Store, 4Sight, Control4 My Home, Mockupancy, and BakPak are also registered trademarks or trademarks of Control4 Corporation. Other names and brands may be claimed as
the property of their respective owners. All specifications subject to change without notice.
a
b
cc c
c
b
a
b
a
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Control4 Neeo Remote Quick start guide
-
Commercial Electric MB-64102 User manual
-
RocketFish RF-ES02 User manual
-
Philips STS8000/00 User manual
-
-
-
-
Control4 Triad User guide
-
Seura SHADE Series Installation guide
-
Seura SHD2-43-Soundbar Outdoor TV Installation guide
