Optical Drive Bezel
Installation Guide
HP rp5800 Retail
System
© Copyright 2011 Hewlett-Packard Development Company, L.P.
Printed in
First Edition: May 2011
Localized Versions of this Document
Localized versions of this document are available at
http://www.hp.com
for the following languages:
Before You Begin
Before installing the drive bezel be sure to power off the
rp5800 and disconnect the power cord from the power outlet.
WARNING! To avoid the risk of serious injury, ensure
that the power cord is unplugged from the electrical
outlet at the wall before installing the bezel. Failure to
do so may expose you to the risk of electric shock.
CAUTION: To avoid the risk of damage to the system,
ensure that the power cord is unplugged from the
electrical outlet before installing the bezel.
Installing the Bezel
1. Turn off power to the system and disconnect the power
cord from the power outlet.
2. Slide the access panel handle toward the rear of the
computer 1 then lift the access panel up and off the
computer 2.
3. Lift up the three tabs on the side of the bezel 1, then
rotate the bezel off the chassis 2.
4. Press each of the clips that secure the driveless section of
the bezel to the front bezel in the direction shown below
to remove the driveless bezel.
5. Insert the clips on the optical drive bezel into the slots on
the front bezel ensuring that the optical drive bezel
snaps securely in place.
6. Insert the three hooks on the bottom side of the bezel
into the rectangular holes on the chassis 1 then rotate
the top side of the bezel onto the chassis 2 and snap it
into place.
7. Slide the lip on the front end of the access panel under
the lip on the front of the chassis 1 then press the back
end of the access panel onto the unit so that it locks into
place 2.
• Dutch • Spanish • Brazilian Portuguese
• English • Japanese • Bahasa Indonesian
• French • Korean • Simplified Chinese
• German • Thai • Traditional Chinese
• Italian
