JO3132 · 12.16.10 Design House is a registered brand of DHI Corp.
Mequon, WI · 800-558-8700
RECESSED TOILET PAPER HOLDER
lf this accessory is to be mounted in an exsting hole first check the dimensions of the hole. This accessory requires a minimum
cut-out of 5
1/8
" x 5
1/8
"
and a maximum of 5
1/2
" x 5
1/2
". lf it is necessary to cut a new hole, please use the template provided on the
back of the product package or on the back of this instruction sheet to ensure the hole is the right size.
After removing the accessory from the package, cut the template along the outer black edge. Then place the template against the
wall where you wish to cut a new hole. Scribe a line around the template. Then cut out the wall board. (lMPORTANT: When
selecting a location, be sure to stay between the wall studs. DO NOT cut a stud.)
INSTALLATION INSTRUCTIONS
INSTALLATION
1. 2.
3. 4.
Attach the clamp to the accessory by inserting
the screws through the accesory into the
bracket. Turn screws three full turns.
Angle the clamp through the hole by first tilting
it to one side, and then the other. Be careful not
to damage the wall board.
Position the accessory squarely with the flange
(outer edge) pressed firmly against the wall.
Tighten the screws until the clamp is firmly
secured against the inside of the wall.
clamp accessory
wall cutout
wall
wall
JO3132 · 12.16.10 Design House is a registered brand of DHI Corp.
Mequon, WI · 800-558-8700
Mounting Bracket Template
Plantilla del Soporte de Montaje
(5
1
/
8
" x 5
1
/
8
")
-
1
-
2
Design House 539254 Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Design House 522136 Installation guide
-
-
-
-
-
-
-
-
-
