Installation and Operation
Option Kit for iPod
T672
1. Installation Instructions (Continued)....................................................................
STEP 1 Open the Display.................................................................................
STEP 2 Prepare to Install the Decoder Board..................................................
STEP 3 Install the Decoder Board....................................................................
2. Operating Instructions..........................................................................................
3. Compatibility Chart...............................................................................................
4. SportsArt Option Kit for iPod Limited Warranty....................................................
TABLE OF CONTENTS
1
2
3
4
6
7
7
LIST OF PARTS
1
No. Name Qty
No.
QtyDescription
A1
A2
A3
A4
A5
2
1
1
1
Assembly Parts
A7
A8
A9
A10
1
1
1
2
4
Decoder board for iPod
Owner's manual
Connector cord
Zip tie
Phillips screw
Mushroom top Phillips screw
Guide wheel
Cable clip (one large, one small)
Flat washer
T672
Please follow instructions below to install the kit for iPod onto the T672 treadmill.
1. INSTALLATION INSTRUCTIONS (CONTINUED)
STEP 1 Open the Display
(a) First, remove screws from the display lower cover.
(b) Open the display upper cover carefully to avoid disconnecting cables. Disconnect
the USB cable connection, and set the display upper cover flat on the handles.
2
STEP 2 Prepare to Install the Decoder Board
(a) Carefully cut off the zip tie.
(b) In area A, remove the small cover. In area B, secure the guide wheel (A7) with the
screw (A6) and washer (A9).
3
STEP 3 Install the Decoder Board
(a) Insert the three cables (that were disconnected earlier) to connectors on the top of
the decoder board for iPod (A1). Insert connector cable (A3) to the bottom of the
decoder board for iPod (A1). Route the connector cord for iPod (A3) around the
column as shown. On the marked area of the heat shrink wrap secure a zip tie
(A4). Use screw (A5) to secure the decoder board (A1) into place on the display
upper cover. Then use screw (A6) to secure the spring end of the connector cable.
On the iPod connector end install cable clip (A8) and secure it into place with a
screw. Note: The marked end of the cable belongs on top. The small cable clip
faces up, and the large clip faces down.
4
STEP 3 Install the Decoder Board (Continued)
(b) Secure the small cover in area . Then, in area , collect the three cables on top
of the decoder board as neatly as possible, and use a zip tie (A4) to secure them
into place. Make sure that these cables do not interfere with operation of the guide
wheel.
Insert the USB cable to the board on the back cover while making sure not to
pinch any cables.
(d) Finally, close the upper cover and secure its screws.
○○
(c)
A
B
5
Applies to T672
Please connect the iPod device to the connector cable for iPod. Insert earphones into
the earphone jack on the product as shown.
Press the play key on the iPod device to select songs. Press the “Vol +/-” key on the
treadmill to adjust music volume.
The battery in the iPod device recharges when connected to the fitness product.
Note: Third generation or newer iPod products have USB recharge capability.
To operate an iPod device on the CardioActive™ Entertainment System, refer to the
CardioActive™ Entertainment System owner's manual.
2. OPERATING INSTRUCTIONS
6
The chart below shows the video support for various iPod devices on Sports Art
products.
3. COMPATIBILITY CHART
iPod device
iPod with video
iPod Touch 1st
iPod Touch 2nd
iPod Classic
iPhone
iPhone 3G
iPhone 3GS
iPod nano
(5 generation)
th
iPod nano
(4 generation)
th
Audio
yes
yes
yes
yes
yes
yes
yes
yes
yes
Fitness Products
with Audio
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
No, video appears only
on iPod screen.
Audio
yes
yes
yes
yes
yes
yes
yes
yes
yes
Fitness Products with
Video
Yes, video appears on the
integrated TV screen on
the SportsArt product.
No, there is audio but the
video image is choppy.
No, there is audio but the
video image is choppy.
No, there is audio but the
video image is choppy.
SportsArt warrants the option kit for iPod to be free from manufacturing defects for a
period of 60 days after purchase: parts, no labor. The customer is responsible for
proper installation. SportsArt's obligation is limited to replacing parts or providing
reimbursement, at the sole discretion of SportsArt Fitness. In the event of a
malfunction, the purchaser is responsible for the return of the original option kit for
iPod to SportsArt Fitness at his/her expense before replacement or reimbursement
can be provided. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER
WARRANTIES EXPRESSED OR IMPLIED, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR PURPOSE. Under no
circumstances shall SportsArt Fitness be liable by virtue of this limited warranty or
otherwise for damage to any person or property in excess of the purchase price of
this optional device, or for any special, indirect, incidental, secondary or
consequential losses, damages or expenses. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
4. SPORTSART OPTION KIT FOR IPOD LIMITED WARRANTY
Yes, video appears on the
integrated TV screen on
the SportsArt product.
Yes, video appears on the
integrated TV screen on
the SportsArt product.
Yes, video appears on the
integrated TV screen on
the SportsArt product.
Yes, video appears on the
integrated TV screen on
the SportsArt product.
Yes, video appears on the
integrated TV screen on
the SportsArt product.
7
Does not yet support Apple's New Lightning Connector.
Note: iPod is a trademark of Apple Inc., registered in the US and other countries.
"Made for iPod" means that an electronic accessory has been designed to connect specifically to
iPod and has been certified by the developer to meet Apple performance standards. Apple is not
responsible for the operation of this device or its compliance with safety and regulatory standards.
14000
/
