JCB JCB-SCH12Li Safety And Operating Manual

Category
Battery chargers
Type
Safety And Operating Manual

JCB JCB-SCH12Li is a battery charger that is compatible with Li-ion batteries. It has a charging current of 500mA and an output voltage of 12V. The charger is protected against deep discharging, and it has a green light that illuminates when the battery is fully charged. It also has a red light that illuminates when the battery is charging. The charger is double insulated and has a protection class of /II.

JCB JCB-SCH12Li is a battery charger that is compatible with Li-ion batteries. It has a charging current of 500mA and an output voltage of 12V. The charger is protected against deep discharging, and it has a green light that illuminates when the battery is fully charged. It also has a red light that illuminates when the battery is charging. The charger is double insulated and has a protection class of /II.

JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
Safety and operating manual
Battery Charger
JCB-SCH12Li
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
WARNING: Read all safety
warnings and all
instructions. Failure to follow the
warnings and instructions may
result in electric shock, fire and/or
serious injury.
- This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and
knowledge, unless they have been
given supervision or instruction
concerning use of the appliance
by a person responsible for their
safety.
- Children should be supervised
to ensure that they do not play
with the appliance.
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
Save all warnings and
instructions for future
reference.
1) Protect the battery charger
from rain and moisture.
The
penetration of water in a battery
charger increases the risk of
electric shock.
2) Do not charge batteries of
other manufacturers.
Danger of
fire and explosion.
3) Keep the battery charger clean.
Contamination may cause the
danger of electric shock.
4) Check the battery charger,
cable and plug each time before
using. Do not use the battery
charger when defects are
detected. Do not open the battery
charger yourself.
Damaged
battery chargers, cables and
plugs increase the risk of electric
shock.
5) Do not operate the battery
charger on easily inflammable
surfaces (e.g. paper, textiles, etc.)
or combustible environments.
There is danger of fire due to the
heating of the battery charger
during charging.
6) When battery pack is not in
use, keep it away from other metal
objects like paper clips, coins,
keys, nails, screws, or other small
metal objects that can make a
connection from one terminal to
another.
7) Under abusive conditions,
liquid may be ejected from the
battery; avoid contact. If contact
accidentally occurs, flush with
water. If liquid contacts eyes,
additionally seek medical help.
Liquid ejected from the battery
may cause irritation or burns.
SAFETY INSTRUCTIONS
ORIGINAL INSTRUCTIONS
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
8) Have your battery charger
repaired by a qualified repair
person using only identical
replacement parts.
This will
ensure that the safety of the
battery charger is maintained.
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
1. Before charging, read the
instructions.
2. If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
3. After charging, disconnect the
battery charger from the supply
mains. Then remove the battery
pack.
4. Do not charge a leaking
battery.
5. Do not use chargers for works
other than those for which they
are designed.
6. Before charging, ensure your
charger is matching the local AC
supply.
7. The charging device must be
protected from moisture.
8. Do not use the charging device
in the open.
9. Do not short out the contacts
of battery or charger.
10. Respect the polarity “+/-”
when charging.
11. Do not open the unit and keep
out of the reach of children.
12. Do not charge the batteries of
other manufactures or ill-suited
models.
13. Ensure that the connection
between the battery charger and
battery is correctly positioned
and is not obstructed by foreign
bodies.
14. Keep battery charger’s slots
are free of foreign objects and
protect against dirt and humidity.
Store in a dry and frost-free place.
15. When charging batteries,
ensure that the battery charger
is in a well-ventilated area and
away from inflammable materials.
Batteries can get hot during
charging. Do not overcharge
any batteries. Ensure that
batteries and chargers are not left
unsupervised during charging.
16. Do not recharge non-
rechargeable batteries, as they
can overheat and break.
17. Longer life and better
performance can be obtained if
the battery pack is charged when
the air temperature is between
18
o
C and 24
o
C. Do not charge the
battery pack in air temperatures
below 4.5
o
C, or above 40.5
o
C.
This is important as it can prevent
serious damage to the battery
pack.
WARNING:
1)This appliance is not
intended for use by persons
(including children) with reduced
physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they
have been given supervision
or instruction concerning use
of the appliance by a person
responsible for their safety.
2)Children should be supervised
to ensure that they do not play
with the appliance.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR BATTERY CHARGER
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
SYMBOLS
Read the manual
Warning
Indoor use only
Double insulation
WEEE marking
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
1. CHARGE INDICATOR LIGHT
2. BATTERY PACK *
3. BATTERY PACK RELEASE BUTTON
4. CHARGER BASE
COMPONENT LIST
1
3
2
4
*
Not all accessories illustrated are included as standard.
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
TECHNICAL DATA
Charger voltage 110-240V~50/60Hz
Output voltage 12V
Charging current 500mA
Power input 13W
Charge battery Li-ion
Protection class
/II
Machine weight 0.14Kg
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
CHARGING PROCEDURE
NOTE:
Before using the
tool, read the safety and
operating manual carefully.
1. CHARGING YOUR
BATTERY PACK
The battery charger supplied
is matched to the Li-ion battery
installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected
against deep discharging. When
the battery is empty, the machine
is switched off by means of a
protective circuit: The chuck no
longer rotates.
In a warm environment or after
heavy use, the battery pack may
become too hot to permit charging.
Allow time for the battery to cool
down before recharging.
When the battery pack is charged
for the first time and after prolonged
storage, the battery pack will accept
a 100% charge after several charge
and discharge cycles.
2. BEFORE USING YOUR
CORDLESS TOOL
Your battery pack is UNCHARGED
and you must charge once before
use. When you charge the new
battery or one which has not been
used for long periods of time, it may
not reach full charge until after you
have discharged it fully in use and
recharged it several times.
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
3. HOW TO CHARGE YOUR
BATTERY PACK (See
1
,
2
)
Connect the battery charger to the
power supply and the green light (1)
will illuminate.
Slide the battery pack into
the charger base to make the
connections. The red light (1) will
illuminate to show charging has
started.
After charging approx 3 - 5 hours,
the red light will switch to green,
indicating the battery is full, and
charging is completed.
2
1
1
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
PROBLEM SOLUTION
1. I CANNOT FIT THE BATTERY INTO THE BATTERY CHARGER. WHY?
1) Check if the charger and the battery pack are specifically designed for working
together.
2) The battery can be inserted into the charger only in one direction. Turn the
battery around until it can be inserted into the slot, the indicator light should be red
when the battery is charging.
2. REASONS FOR DIFFERENT CHARGING TIMES
The charging time can be affected by many reasons which are not defects in your
product.
1) If the battery pack is only partly discharged it may be re-charged in less than 3 -
5 hours.
2) If the battery pack and ambient temperature are very cold then re-charging may
take more hours.
3) If the battery pack is very hot you must remove your battery pack from the
charger and allow your battery pack to cool first to ambient temperature and then
recharging can be started.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or maintenance. Never use water or
chemical cleaners to clean your tool. Wipe clean with a dry cloth. Always store
your tool in a dry place.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or retailer
for recycling advice.
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
WARRANTY STATEMENT
Cutting edge construction technology in your hands
In 1945 JCB began producing construction equipment. Today, we build the world’s
number one diggers, each one the product of our unswerving focus on innovation,
quality and engineering. JCB power tools are built to give you the same world
beating standards of performance. The same innovation, to always get the job
done better, the same quality, to never let you down, the same engineering
heritage and expertise that you can trust 100%.
JCB power tools are guaranteed against manufacturing defects for a period of 5
years from the date of purchase. If your JCB power tool becomes defective within
this warranty period, we guarantee to:
• Replaceorrepairalldefectiveparts,freeofcharge,or
• Repairproductsfreeofcharge,or
• Replacetheunitwithaneworre-conditionedunit,freeofcharge.
Conditions
Your 5 year guarantee does not cover defects caused by or resulting from:
• overload,misuse,orneglect
• normalwearandtear,includingaccessorywear
• tradeorhireuse
• repairsattemptedbyanyoneotherthananauthorisedagent
• damagecausedbyforeignobjects,substancesoraccidents
Your 5 year guarantee does not cover:
• batterypacksastheyareguaranteedfora12monthperiod
• accessoriessuppliedwiththepowertool.
Warranty claims
For guarantee claims, please contact JCB Customer Services. You will be required
to submit proof of purchase.
JCB CUSTOMER HELPLINE 0845 600 5526
Terms
This guarantee does not affect your statutory rights. JCB SO53 3LE (Registered in
England under No. 973387).
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0845 6005526
EC DECLARATION OF CONFORMITY
We,
Positec Power Tools RG24 8AL, UK
Declare that the product
Description
JCB Battery Charger
Type
(JCB-SCH12Li)
Complies with the following Directives,
EC Low Voltage Directive
2006/95/EC
EC Electromagnetic Compatibility Directive
2004/108/EC
RoHS Directive
2011/65/EU
Standards conform to
EN 60335-1
EN 60335-2-29
EN 55014-1
EN 55014-2
EN 61000-3-2
EN 61000-3-3
EN 62233
The person authorised to compile the technical file,
Name: Russell Nicholson
Address Positec Powertools(Europe) LTD
Pinewood, Chineham Business Park,
Basingstoke, Hampshire, RG24 8AL, United Kingdom
2013/04/09
Leo Yue
Quality Manager POSITEC
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

JCB JCB-SCH12Li Safety And Operating Manual

Category
Battery chargers
Type
Safety And Operating Manual

JCB JCB-SCH12Li is a battery charger that is compatible with Li-ion batteries. It has a charging current of 500mA and an output voltage of 12V. The charger is protected against deep discharging, and it has a green light that illuminates when the battery is fully charged. It also has a red light that illuminates when the battery is charging. The charger is double insulated and has a protection class of /II.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI