COMP Cams 12146 Operating instructions

Type
Operating instructions

This manual is also suitable for

COMP CamsĀ®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #COMP4-124
Revised 1/18/11
Carbon Ultra-Poly Gears
#12200, 12140, 12146, 12149, 35100*, 35200*
Tech Note
Due to different tolerances in OE and aftermarket distributors, COMP CamsĀ® has only drilled
one side of your new Carbon Ultra-Poly gear so that it can be matched to your distributor shaft.
Check the hole sizes on your distributor as they vary by manufacturer.
Instructions
Install the Carbon Ultra-Poly Gear on the distributor shaft, using the single hole in the gear to
match the hole already in the distributor shaft as a guide. Using a drill press, drill though the
other side of the Carbon Ultra-Poly Gear using a drill bit matched to the hole in the shaft. Low
speed is recommended to prevent cracking of the gear.
*NOTE: If your gear already has two drilled holes, disregard these notes.
  • Page 1 1

COMP Cams 12146 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI