COMP Cams 103 is a high-performance camshaft designed to improve the power and torque of your engine. It is made from high-quality materials and features a precision-ground profile for optimal performance. The COMP Cams 103 is a great choice for street and strip applications, and it can help you to get the most out of your engine.
COMP Cams 103 is a high-performance camshaft designed to improve the power and torque of your engine. It is made from high-quality materials and features a precision-ground profile for optimal performance. The COMP Cams 103 is a great choice for street and strip applications, and it can help you to get the most out of your engine.
COMP Cams®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #COMP4-107
Revised 3/4/08
MATERIAL SAFETY DATA SHEET
Cam & Lifter Installation Lube
Part Numbers 103, 152 and 153
DOT HAZARDOUS CLASSIFICATION: NOT APPLICABLE
NFPA HEALTH HAZARD: 1 FLAMMABILITY: 0 REACTIVITY: 2 PERSONAL PROTECTION: B
SECTION 01-HAZARDOUS INGREDIENTS
CASE NUMBER
TLV PEL %
(HAZARDOUS) COMPONENTS
ZINC DITHIOPHOSPHATE
68649-42-3 10 TO 16
(NON HAZARDOUS) COMPONENTS
PARAFFINIC PETROLEUM OIL
ANTHRAQUINONE DYE
64741-88-4
14233-37-5
1 TO 10
<1 by weight
SECTION 02-PHYSICAL DATA
VISCOSITY......................40-48 CsT @ 210° F PERCENT VOLATILE BY VOLUME…………………………………………….NA
BOILING POINT…………………………680° F EVAPORATION RATE…………………………………………………………....NA
VAPOR PRESSURE (mm Hg)………….…NA SOLUBILITY IN WATER……………………………………………….INSOLUBLE
VAPOR DENSITY (Air=1)…………….……NA APPEARANCE AND ODOR…………RED LIQUID WITH MILD OILY ODOR
SPECIFIC GRAVITY (Water=1)……..…0.958
SECTION 03-FIRE AND ELPLOSION HAZARDS
FLASH POINT: (ASTM D92) C.O.C. 402° F UPPER FLAMMABLE LIMIT: NA
LOWER FLAMMABLE LIMIT: NA
EXTINGUISHING MEDIA: DRY CHEMICAL, CARBON DIOXIDE, HALOGENATED AGENTS, FOAM
SPECIAL FIRE FIGHTING PROCEDURES: RECOMMEND WEARING SELF-CONTAINED BREATHING APPARATUS. AVOID
BREATHING FUMES.
UNUSUAL FIRE & EXPLOSIVE HAZARDS: TOXIC FUMES, GASSES, OR VAPORS MAY EVOLVE ON BURNING.
SECTION 04-ENVIRONMENTAL AND DISPOSAL INFORMATION
ACTION TO BE TAKEN FOR SPILL/LEAKS: Personal protective equipment must be worn. Ventilate area if spilled in confined
spaces or poorly ventilated areas. Check all Federal and State laws for proper methods of hazardous substance spill control.
DISPOSAL METHOD: Material, if discarded, not expected to be a characteristic hazardous waste under RCRA. Disposal should
be in compliance with Federal, State, or Local laws. Do not discharge into sewers or waterways. Properly discard bottle after use,
never reuse for other purpose.
SECTION 05-HEALTH HAZARD DATA
ORAL TOXICITY: THE LD50 IN RATS IS GREATER THAN 5g/kg. Based on actual data.
EYE IRRITATION: SEVERE EYE IRRITANT. EXPOSURE WILL CAUSE REDNESS, SWELLING AND DISCHARGE FROM
EYES. Based on actual data.
SKIN IRRITATION: MODERATE SKIN IRRITANT. PROLONGED CONTACT WILL CAUSE SKIN REACTION. Based on similar
materials.
DERMAL TOXICITY: THE LD50 IN RABBITS IS GREATER THAN 2g/kg. Based on actual data.
MSDS
COMP Cams®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #COMP4-107
Revised 3/4/08
EXPOSURE LIMITS: THIS PRODUCT CONTAINS 1 TO 10% MINERAL OIL (CAS #8012-95-1). THE OILS IN THIS PRODUCT
ARE SEVERELY SOLVENT REFINED AND/OR SEVERELY HYDROTREATED.
TLV=5mg/cubic meter ACGIH STEL=10mg/cubic meter
EMERGENCY FIRST AID PROCEDURES
:
EYES: Flush with water for at least 15 minutes. See physician if irritation develops or persists.
SKIN: Wash with soap and water. See physician if irritation develops. Launder contaminated clothing before reuse and discard
shoes and other leather articles saturated with the material.
INHALATION: If adverse effects are observed, remove affected person to fresh air. Seek medical attention.
ORAL: Call a physician. Do not induce vomiting.
SECTION 06-REACTIVITY DATA
STABILITY: Stable
INCOMPATIBILITY: Acids and strong oxidizers such as chromates, permanganates, and chlorates.
POLYMERIZATION: Will not occur
THERMAL DECOMPOSITION: Smoke, carbon monoxide, aldehydres, carbon dioxide. Oxides of sulfur, oxides of phosphorus,
zinc oxides, or oxides of nitrogen can or may be formed or released when burned.
SECTION 07-SPECIAL PROTECTION INFORMATION
VENTILATION: Use adequate ventilation to control mists and vapors.
RESPIRATORY: None required under normal conditions of use.
GLOVES PROTECTION: Neoprene gloves.
EYE PROTECTION: Safety glasses, safety goggles, or face shield.
OTHER PROTECTION: Use of long sleeve shirt is advisable. Remove rings, watches, or similar items that could cause the
lubricant to be entrapped on skin surface. Always launder contaminated clothing before reuse.
SECTION 08-SPECIAL PRECAUTIONS AND ADDITIONAL INFORMATION
Keep bottles closed when not in use. Store away from heat, sparks, and open flames. Wash thoroughly after handling. Launder
contaminated clothing before reuse.
-
1
-
2
COMP Cams 103 Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
COMP Cams 103 is a high-performance camshaft designed to improve the power and torque of your engine. It is made from high-quality materials and features a precision-ground profile for optimal performance. The COMP Cams 103 is a great choice for street and strip applications, and it can help you to get the most out of your engine.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
COMP Cams 7114 Operating instructions
-
-
-
-
COMP Cams 7100 Operating instructions
-
-
-
COMP Cams 127400-4.6/5.4-liter 2 and 3 valve engines camshaft Operating instructions
-
-
Other documents
-
Ideal Anti-Oxidant Compound 4 oz. User manual
-
Akzo Nobel LN-901 User guide
-
UniTherm BF-6-8-5 Operating instructions
-
Power Fist 8882615 Owner's manual
-
Sigma Electric 14233 Installation guide
-
ProRestore ODORx Crystal Odor Counteractant Professional Cherry User guide
-
ProRestore ODORx Crystal Odor Counteractant Commercial Cherry User guide
