Portable Bar Company COMPACT BAR Setup Manual

  • Hello! I am an AI chatbot trained to assist you with the Portable Bar Company COMPACT BAR Setup Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Table of contents:
- Part List
- Set Up Guide
- Compact Bar Covers
COMPACT BAR SET UP GUIDE
• Read all the instructions before installing.
• Remove all packing materials before you start.
• This installation requires basic mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under
the warranty.
• Keep this instruction manual.
BEFORE YOU BEGIN THE INSTALLATION
PAGE 2 OF 8
COMPACT BAR ASSEMBLY PART LIST
PAGE 3 OF 9
Main Frame
QTY: 1
Counter Top
QTY: 1
Speed Rail
QTY: 1
Ice Bin
QTY: 1
Lock Pin
QTY: 5
Note: Parts are not to scale.
Acrylic Panel
QTY: 4
Cutting Board
QTY: 1
Cover
QTY: 1
See page 7
COMPACT BAR ASSEMBLY SET UP STEPS
STEP 1: Remove the pins and . Unlock the spring
latches at the bottom ( ).
-
P1 P2
L1 L2
P1
P2
L1
L2
STEP 2: Open the doors as shown below.
Figure 1
Figure 2
CAUTION: The doors slide down when fully open.
See Figure 3.
Figure 3
PAGE 4 OF 9
STEP 3: Place the side pins as shown below ( ).
-
Remove pins and .
P1 P2
P3 P4
P3
P1
P2
P4
Figure 4
Note: Adjust levelers to desired
lenght for added stability.
Note 2: Pins may look
and
like the pin below:
P1 P2
COMPACT BAR ASSEMBLY SET UP STEPS
STEP 4: Lift the shelf and place the pins and
as shown below.
P3
P4
STEP 5: Set down the shelf and remove the pin
as shown below.
P5
PAGE 5 OF 9
STEP 6: Insert the pin .
P5
P3
P4
P5
P5
Figure 5
Figure 6
Figure 7
STEP 7: Place the counter top as shown below. Lock the counter
top in place using the two spring latches and
L3 L4
L3
L4
Figure 8
STEP 8: Place the speed rail and the ice bin
as shown below.
Figure 9
Figure 10
COMPACT BAR ASSEMBLY SET UP STEPS
PAGE 6 OF 9
How to remove the acrylic panels if needed
Back Panel
STEP 1: Remove screws and . Then remove
the tab as shown below.
S1 S2
S1
S2
STEP 2: Pull up the acrylic panel.
STEP 1: Remove screws and . Then remove
the side frame as shown below.
S3 S4
STEP 2: Slide out the side panel.
STEP 1: Remove screws and .
Slide out the panel.
S5
S6
S3
S4
S5
S6
Side Panel
Top Panel
COMPACT BAR ASSEMBLY SET UP STEPS
PAGE 7 OF 9
Figure 11. Full Assembly.
COMPACT BAR COVERS
PAGE 8 OF 9
Speed rail cover
Main frame cover
Counter cover
Contact us
Tel # 877-958-7901
866-659-3353Fax #
info@theportablebarcompany.comE-mail:
Visit us at
www.theportablebarcompany.com
COMPACT BAR SET UP GUIDE - 12/23/2016
/