DataComm Electronics 21628 Installation guide

Brand
DataComm Electronics
Model
21628
Type
Installation guide

This manual is also suitable for

DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.DataCommElectronics.com
Tools Needed
Philips Head Screw Driver
Installation
1. Before installing the Décor Insert with Flexible Opening, you must first install a low
voltage mounting bracket (sold separately) into the wall. Refer to the instructions on
the low voltage mounting bracket for assistance.
2. Run up to 4 (four) low voltage A/V cables through the opening in the low voltage
mounting bracket, and then through the opening of the Décor Insert.
3. Place the Décor Insert against the low voltage mounting bracket. Using the two (2)
included screws, screw the Décor Insert into place on the low-voltage mounting
bracket.
4. To give your installation a finished look, install a décor wallplate (sold separately) over
the Décor Insert.
Instruction / Installation Sheet
Décor Insert with Flexible Opening
Part # 45-0016
RoHS Compliant
Use the Décor Insert with Flexible Opening to
install low voltage cables behind your HDTV,
amplifier or other audio video devices. The Décor
Insert with Flexible Opening is designed to be
installed onto a low voltage mounting bracket
(sold separately) that is installed into the wall.
• This product is designed for use with low
voltage cable ONLY.
• DO NOT run or pull a TV cord or other
electrical cords inside the wall.
• It is a violation of the National Electric Code
(NEC) to run power cords or extension
cords behind the wall.
This product is patent protected by U.S. Patent number 7495171.
Caution:
• Never install low voltage wiring during lighting storms.
• Never touch un-insulated wires or terminals unless the wire has been disconnected at
its network interface.
• Use caution when installing or modifying data or telecommunication lines.
• DO NOT alter, change, or disconnect existing telecommunication wires if you are
unsure of their purpose or function.
• It is NOT recommended to install this product in close proximity to an electrical service
panel to prevent interference from electrical current.
Important Instructions:
• Read and understand all instructions.
• Do not use this product near water, for example near bath tub, wash bowl, kitchen,
sink, or laundry tub, in a wet basement, or near a swimming pool.
• SAVE THESE INSTRUCTIONS.
  • Page 1 1

DataComm Electronics 21628 Installation guide

Brand
DataComm Electronics
Model
21628
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents