Leverage - Installation Checklist
Use the checklist below to ensure proper installation of Star Trac Leverage Strength:
Upon receipt inspect packaging for damage – Report all damages to Core Health and Fitness notate all
damages on the BOL
Ensure all hardware and parts in the package are accounted for
Ensure all pivot point lock nuts are pressed into the arm shaft once prior to applying to lock tab washer
to ensure the proper torque spec can be reached without damaging the lock washer. Once the
bearings have been pressed in remove the nut and apply the lock washer, reapply the lock nut to the
specified torque value and lock in the tab washer.
Ensure all screws, bolts, and nuts are tightened and torqued down to their specified values per the
instruction manual. This includes all pre assembled parts
Check for proper alignment of all adjustment arms. Realign as needed.
Make sure the proper instruction placards and warning labels are correct and not damaged or missing
Check all weldments for straightness, perpendicularity and parallelism
Ensure all upholstery hardware is tight upon final placement
Verify condition of upholstery, check for marks or cuts.
Conduct a full function test of the unit to ensure smooth operation
Overall visual & cosmetic inspection: All equipment is to be wiped down and checked for defects prior to
leaving the facility. Installer is to contact an authorized Core Health & Fitness representative while on site, if
there are any issues that have not been resolved.
Assembly & Setup
