Page is loading ...
Atomrock Camera Installaon Guide
DC120
Privacy and Support
To protect customer’s private informaon, Atomrock promises
to keep them confidenal, and will not disclose any informaon
to a third party without permission.
To learn more about privacy, please refer to our privacy policy
at: www.atomrock.com/privacy
To register, to get support, to obtain the latest product informa-
on, compliance informaon, and to download the latest
updates at:
www.atomrock.com/support
help.atomrock.com
In the box
Camera
3 Screws 3 Anchors Waterproof connector
Drilling guide
Before Installaon
1. Check your firewall and router for required Internet connecvity.
TCP/UDP port 443 needs to be opened for secured data transmission
with the cloud.
2. It is strongly recommended to use POE switch for Atomrock’s camera
product. Please check that your switch supports 802.3af POE standard.
3. You should already have an invitaon email, which was sent during
purchase, to acvate your Atomrock account. Please login and add the
camera with its serial number and its proper license.
4. Check to see that you have a Phillips screwdriver or power drill with
Phillips screwdriver bit.
Other items you may need
1. Drill bit
2. A ladder - please ensure safety first.
Installaon Help
Please refer to help website for more informaon about installaon:
help.atomrock.com
Start Installaon
2.Install the camera
Opening the camera’s shell, you
should see three holes on camera
base. Match the holes between the
camera base and the wall. Lock them
up with the screws and put the
camera’s shell back and lock it. For
weatherproof installaon, all three
connecons need to be weatherght.
Please use the weather sealing cap
and appropriate weather sealing tapes
on all joints.
1.Drill installaon point
Take the drilling guide and place it
on the wall or ceiling. Check
drilling points and carefully use
power drill to drill holes. Aer
drilling the holes, put the anchors
into those holes.
For more informaon or support, please visit our support website: help.atomrock.com
4. Access Enterprise Cloud UI
Go the Atomrock enterprise cloud
(cloud.atomrock.com) and login.
Check the camera status and
views. You can manually change
the camera’s direcon or angles
with the camera view.
Add license to enable cloud
recording and smart analysis
funcons here.
3. Connect to the Net
Connect your Ethernet cable from
your switch to the camera, and
check the instrucon light on the
Ethernet socket to make sure the
camera’s power is on.
! By default, Atomrock device acts
as DHCP client. Please check our
support site for documentaon
about deploy on network without
DHCP.
5.Your new Cloud-enabled surveillance system is ready to work!
Noce
This label indicates that this product should not be disposed of
with household waste. It should be deposited at an appropriate
facility to enable recovery and recycling. Please refer to informa-
on on how to recycle this product responsibly in your country.
WARNING: A WARNING indicates a potenal for property damage,
personal injury, or death.
WARNING: Do not operate your equipment with any cover(s)
removed.
WARNING: Use of controls, adjustments, procedures, connecons,
or signal types other than those specified in your documentaon
may result in exposure to shock, electrical hazards, and/or
mechanical hazards.
/