Stratis IoT BBB Cape V1.0 User manual

  • I have reviewed the setup instructions for the Artis Cape. This document outlines the steps for physically connecting the Artis Cape to a beaglebone, attaching the antenna, and using the UART cable. I am ready to answer your questions regarding the setup process.
  • How should the cape be attached to the beaglebone?
    Where is the antenna connected?
    Which connectors are connected to the exposed pins?
Artis Cape Setup Instructions
1. The cape should already be attached to the beaglebone. If not, line up the pins on the
cape with the sockets in the beaglebone; there is only one orientation where the cape
will fit all the way down onto the beaglebone.
2. Attached the included antenna to the gold antenna connector on the cape.
3. Connect the yellow, orange, and black connectors to the exposed pins on op of the
cape, as shown in the image below.
4. Plug the other end of the UART cable into the computer.
5. Plug the beaglebone into power (either through USB or the included power supply)
6. Now the cape should be detectable through the PC controller application.
/