CORRECTION
Operating instructions P.17
BEFORE AFTER
CDJ-1000 <DRM1244-A>
7 Data other than CUE/LOOP stored on MMC
¶ Hot cue points A, B, C
Hot cue points A, B and C are automatically stored on MMC. When a disc storing
hot cue points is inserted, the [A], [B] and [C] indicators light in green. To call
stored hot cue points, press the A, B or C button.
If there has been no call for thirty seconds then the A, B and C buttons will go out.
To call the hot cue point after the lights go out, remove and replace the disc and the
A, B and C buttons will blink on and off, at this time it is possible to call.
¶ WAVE display
When a wave display for one track is completed it is automatically stored on the
MMC. When the same track is played again, the stored WAVE display is automati-
cally called. Data for items beyond track number 21 are stored on the MMC.
7 Data other than CUE/LOOP stored on MMC
¶ Hot cue points A, B, C
Hot cue points A, B and C are automatically stored on MMC. When a disc storing
hot cue points is inserted, the [A], [B] and [C] indicators light in green. To call
stored hot cue points, press the A, B or C button.
The green flashing indicator will light steadily (when the call is made, sound will
be interrupted briefly). If call is not needed, press the HOT CUE REC MODE
button. The indicator will change to red, and you can set the hot cue point. To call
the hot cue point, remove and replace the disc or MMC and the A, B and C buttons
will blink on and off, at this time it is possible to call.
¶ WAVE display
When a wave display for one track is completed it is automatically stored on the
MMC. When the same track is played again, the stored WAVE display is automati-
cally called. Data for items beyond track number 21 are stored on the MMC.
