L’ Square High Chair
INSTRUCTION MANUAL
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE AS YOUR CHILD’S SAFETY DEPENDS ON IT.
-Suitable for babies that can sit up unaided approximately 6 months
-Suitable for babies with a maximum weight of 15kgs approximately 3 years.
-Complies with BS EN 14988 -1, 2006+A1 2012
-Adult assembly required
1. Parts.
Please keep all packaging until you are sure no parts are missing. Carefully dispose all packing
material, packaging and plastics that may result in suffocation if swallowed.
DO NOT USE IF ANY PARTS ARE MISSING OR BROKEN
1. Seat unit
2. 2.Two Part Serving Tray
3. Lower legs front & rear
4. Upper legs with height adjustment left & right
5. Foot rest & Securing screws
6. Stop washer & Screw
7. Seat cover (not shown)
Assembly
2. Fixing the Upper Leg
-Take the left or right upper leg, press the red (a) button as shown in diagram 2 and extend the leg and
release the button once the leg has been extended. Repeat the same with the other leg.
-Looking at the orientation in the diagram 2 put the front leg (the red button facing outside) through the
seat height adjustment bracket. Repeat the same with the other leg.
3. Fixing the Lower Leg
-Please note each of the four legs has a spring loaded pin. Line up the feet so the small hole to the pin.
Push firmly on both ends until the pin clicks into place of the hole of the lower leg as illustrated in
diagram 3.
4. Attaching the Footrest.
Attach the footrest under the seat unit till it clips on. Secure the footrest using screws provided. The
screws are to be fixed from the rear as shown on the diagram 4.
5. Fitting the Seat Cover.
Slide the pocket at the back of the seat cover over the seat unit as shown in diagram 5. Ensure the studs
are fastened on each side. ALWAYS CHECK THE STUDS AND HARNESS IS FIXED CORRECTLY. DO NOT
USE IF SEAT OR ANY PART OF THE SEAT IS TORN OR DAMAGED
6. Fitting of Tray
Position the tray over the arms and press the leaver under the tray to slide the tray into position
required. The upper tray can be removed by holding the two ridges on either side and pulling it and can
be put back by pushing it into space ensuring it is secure. The tray can be stored behind the pegs that
are on the rear legs of the high chair. Align the holes on the back of the tray with the pegs.
7. Harness
A five-point safety harness is provided for the safety of your child and should always be worn. Sliding
adjusters are fitted and should be carefully adjusted so the harness fits your child comfortably. To fasten
the harness, push the prongs into the buckle. To release, push the prongs (A) and remove from the
buckle.'0 ' rings are fitted at the end of each waist and crotch straps through the vertical slots in the
lower backrest, rotate the ends, and pull back the secure.
8. Adjusting the seat Height & Recline
Warning: Do not adjust the height of the seat whilst the child is seated in the chair.
To adjust the height of the seat push in both of the height adjusting locks diagram 8(A) and
simultaneously raise or lower the seat, releasing both of the locks at the required height.
To adjust the angle of the seat, lift the plastic lever (B) (found on the back of the seat unit) and positions
requires, releasing the mechanism to secure into place.
DO NOT recline the seat unit when highchair is in highest position.
9. Folding the High Chair
For a more compact fold fit the tray to the back of the highchair. To fold the highchair, press in both of
the release catches on the side legs and slide the near legs forward. Check the highchair is correctly
folded before leaving to stand free. Keep chair away from child reach.
3.Care & Maintenance
-The correct use and maintenance of the high chair is essential
- Always ensure the product is stored in a dry place to prevent mould or mid developing on the product.
-Avoid leaving the high chair under direct sunlight for long period as it may damage the product.
-Metal, Plastic parts & Seat should be cleaned with a damp cloth and wiped dry with a soft cloth.
-Clean harness with a mild soap and allow to dry and re-use
-DO NOT USE ABRASIVE CLEANERS OR BLEACH
- DO NOT USE IF ANY PART IS BROKEN, MISSING OR TORN AND NO SHARP EDGES HAVE BEEN EXPOSED
-Inspect studs, nuts and screws for tightness. Check all harness and strap attachments are secure and
fitted correctly.
-Do not use replacement parts other than those approved by manufacturer or distributor.
SAFETY WARNINGS
- WARNING: Never leave your child unattended
- WARNING: Your child’s safety is your responsibility
- WARNING: Do not use the high chair unless all components are correctly fitted and adjusted
- WARNING: Be aware of open fire and other sources of strong heat, such as elements, radiators, etc.
- Do not use for a child weighing more than 15kgs
- Only suitable for children who can sit unaided
- Always use the 5 point harness provided. Ensure that it is correctly fitted and adjusted before use
- Adult assembly required. Always ensure the high chair has been assembled correctly before use
- Ensure that the child is kept away from the high chair when assembling, opening and folding the
high chair to avoid entrapment
- Do not allow children to play with the high chair. It is not a toy. Store safely out of reach
- Never carry the high chair with the child in it
- Please lift the child in and out of the high chair. Do not allow children to stand on the footrest
- Only use the high chair on level floor surfaces. Do not use near staircase
- Never use accessories or fittings that have not been approved by the manufacturer.
This product complies with BS EN 14988 -1: 2006 + A1 :2012
BABYCO HA9 0JD CUSTOMER SERVICE 020 8909 9898
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
ROOMS TO GO 70398930 Assembly Instructions
-
-
Cuggl LHB-008 User manual
-
Chipolino High chair Master Chef Operating instructions
-
Cosatto Noodle Supa User manual
-
-
-
Graco CONTEMPO Owner's manual
-
-
Dorel casper User manual