Page is loading ...
STEP 5
Attach Cabinet Door (C) by lining it
up on the 1” Pin on Cabinet Bottom
(B) as referenced in Step 3 with top
1” Pin being inserted into bottom of
Cabinet Top (E) predrilled hole as
shown on right. Fasten Cabinet Top
(E) using four 1-1/4” screws.
STEP 6
Attach Drawer Pull to Drawer (F)
by inserting through holes in
Drawer (F) and securing with pull
screws provided.
Attach Door Pull the same vertically
with pull assembled to face on top.
STEP 7
Slide Drawer in on Side Assembly
(A) slats and push both Drawer Stop
Dowels on predrilled holes on top of
Drawer (F) as shown on right.
STEP 8
Attach Magnet Plate with ½” Flat
Screw on Cabinet Door (C) as
shown on right.
STEP 9
Place Top (G) onto Side Assemblies
(A) and fasten with remaining 1-
1/4” screws as shown on right.
STEP 10
Insert flush plugs to cover screws
in Side Assemblies (B) and tap
lightly into place with a hammer.
CARE
Dust as needed with soft cloth. Clean with
damp cloth and mild solution of dish soap.
Polish with soft cloth and polish that
contains no pigment or silicone.
www.llbean.com
Product Support 1 800 341 4341
Mission Cabinet Small
Thank you for purchasing our Mission Cabinet Small. Assembly of this
product requires a Phillips screwdriver (screw gun with Philips head
recommended) and a hammer. We have found it helpful to have a second
person present in at least one step of the assembly.
7573 05AG1160111
Read through these instructions
thoroughly. We have found this to be
of great value when first assembling
this product.
Remove all parts and hardware from
packing material. Place wooden parts
on non-abrasive surface (like carpet
or carton) to prevent damage to finish.
Assembly of this product requires a
Phillips screwdriver and a hammer.
Identify and count hardware using
diagram at right.
Identify all parts using diagram at
right.
2 Side Assemblies (A)
1 Cabinet Bottom (B)
1 Cabinet Door (C)
1 Cabinet Back (D)
1 Cabinet Top (E)
1 Drawer (F)
1 Top (G)
STEP 1
Please review which way you would like
the cabinet to open. As shown on the
right, the Cabinet Bottom (B) has
predrilled holes on the surface. If you
choose the 1” Pin in Step 4 facing your
left side, the cabinet door will close on
the right and vice versa.
After you’ve chosen left or right, attach
Cabinet Bottom (B) as suggested to Side
Assembly (A) using two 1-1/4” screws
inserting them through the Side Assembly
(A) then into the predrilled holes in
cleats. Please note: the pre-grooved
slots in Side Assemblies (A) should be
on opposite side of pinholes (on back of
unit).
STEP 2
Slide Cabinet Back (D) into pre-grooved
slot into (A) Side Assembly as shown on
right. Repeat Step 1 with attaching
second Side Assembly (A) and be sure
Cabinet Back (D) is placed into its pre-
grooved slot as well when you secure
both sides.
STEP 3
Drop 1” Pin with 2 washers in
Cabinet Bottom (B) in predrilled
hole as shown on nearest right.
Insert 1” Pin in top of Cabinet Door
(C) as shown on right. Place the
bottom of Cabinet Door (C) onto
bottom 1” Pin on Cabinet Bottom
(B).
STEP 4
Fasten Magnet using two ½” Pan
Screws into bottom of Cabinet Top
(E) as shown on right using
predrilled holes. Place it on the side
the Cabinet Door (C) will close on.
/
