Fishbone Offroad FB51334 Installation guide

JL/JLU Wrangler & JT Gladiator

Front, Rear, & Full Sun Shades

FB51305, FB51306, FB51331, FB51332 FB51333, FB51334, FB5133500

FB51305, FB51306, FB51331, FB51332

FB51333, FB51334, FB51335

REQUIRED TOOLS

Help of a Friend

KIT CONTAINS

Sun Shade

Small Bungee

Medium Bungee

Large Bungee

JL/JLU Wrangler & JT Gladiator

Front, Rear, & Full Sun Shades

FB51305, FB51306, FB51331, FB51332 FB51333, FB51334, FB5133500

FB51305, FB51306, FB51331, FB51332

FB51333, FB51334, FB51335

1) REMOVE FREEDOM TOP/HARD & SOFT TOP

Begin removing your Freedom Top panels and

Hard/Soft Top covers. *This isn’t required, but it

will make the installation of the bungee cords very

difficult.

Begin planning where you will need to wrap the

cords. All shorter bungees are used on the sides,

while the longer bungees are for corners and the

sport/sound bars. Remove anything that may get in

the way during installation.

2) INSTALL

Begin attaching the shade so that the logo patch

faces down. The Full Shade with have the logo

facing up. The Front Shade can be oriented in any

way, but the Rear and Full Shades are directional.

The angled corners in the Rear Shade face toward

the front of the vehicle, and the holes in the Full

Shade go over the Freedom Top pins in the sound

bar.