iTEC PB12000 Datasheet

Category
Power banks
Type
Datasheet

iTEC PB12000

Below you will find brief product information for iTEC PB12000. This portable battery, with a capacity of 12000 mAh is used for charging hardware devices (e.g., mobile phones, GPS navigators, tablets, music players) when travelling.

iTEC PB12000 has two output USB ports (USB type A) for charging the connected devices and one input USB port (Micro USB type) for charging the power bank itself. Supplied with a micro USB cable, it features four LED diodes indicating the corresponding battery capacity level.

iTEC PB12000

Below you will find brief product information for iTEC PB12000. This portable battery, with a capacity of 12000 mAh is used for charging hardware devices (e.g., mobile phones, GPS navigators, tablets, music players) when travelling.

iTEC PB12000 has two output USB ports (USB type A) for charging the connected devices and one input USB port (Micro USB type) for charging the power bank itself. Supplied with a micro USB cable, it features four LED diodes indicating the corresponding battery capacity level.

Recommended products
i-tec Power Bank 3400 mAh with Detachable Cable
P/N: PB3400W
?A portable battery with a capacity of 3400 mAh
?For charging of mobile phones, GPS navigators,
tablets, music players and other digital devices
?Ideal solution for travelling where you cannot recharge
your devices from the mains
?4 LED diodes indicating the current battery capacity
level
?Control by a single ON/OFF button
?Slim design and low weight
?Detachable USB cable placed around the power bank
perimeter
i-tec USB Quatro Cable Charger 4 Port
P/N: CHARGER4C
?Network-based USB charger
?Fast and efficient charging of mobile
equipment
?Charging up to 4 pieces of USB equipment
simultaneously
?Special identification circuits for the
iPad/iPhone and Samsung phones and
tablets
i-tec USB Power Quatro Charger 4 Port
P/N: CHARGER-FB4
?Network-based USB charger
?Fast and efficient charging of mobile equipment
?Charging up to 4 pieces of USB equipment
simultaneously
?Special identification circuits for the iPad/iPhone
and Samsung phones and tablets
Recommended products
i-tec Bluetooth Music Receiver with AC 230V
Adapter
P/N: BT2HIFI
?Wireless stereo audio receiver for playing
the music
?Turn your favourite loudspeakers or stereo
system into a wireless system for your
mobile phone, tablet or computer
?Equipped with power adapter and
compartment for 1x AAA battery allowing
convenient use on your travels
?Supplied with 3,5 mm audio cable and 3,5
mm / 2x RCA cable
i-tec USB 3.0 Metal Charging HUB 10 Port
P/N: U3HUBMETAL10
i-tec USB 3.0 Metal Charging HUB 7 Port
P/N: U3HUBMETAL7
i-tec USB 3.0 Metal Charging HUB 4 Port
P/N: U3HUBMETAL4
?Active HUB
?10x / 7x / 4x USB 3.0 port
?Compatible with USB 2.0 / 1.1
?USB charging detection mechanism for
mobile devices for all 10 / 7 / 4 ports
?Plug & Play
?Power adapter
i-tec USB 3.0 Dual Docking Station + USB Charging
Port
P/N: U3HDMIDVIDOCK
?1x DVI-I port
?1x HDMI port
?1x Fast USB 3.0 port for charging of USB devices
?1x USB 3.0 port type A
?4x USB 2.0 port type A
?1x USB 3.0 port type B
?1x Ethernet 10 / 100 / 1000 Mb/s GLAN RJ-45 port
?1x 3.5 mm audio output for earphones /
loudspeakers
?1x 3.5 mm input for a microphone
POWER BANK 12000 mAh
DESCRIPTION
ENGLISH ...................................................................................05-06
DEUTSCH ..................................................................................07-08
ÈESKY .......................................................................................09-10
POLSKI .....................................................................................11-12
SLOVENSKY .............................................................................13-14
LIETUVOS ................................................................................ 15-16
WEEE ..............................................................................................17
DECLARATION OF CONFORMITY ...............................................18
A - USB output 1A
B - USB output 2.1A
C - Micro USB input 1A
D - ON/OFF button
E - LED lights
F - Micro USB cable
i-tec Metal Power bank 12000 mAh
EN
05
ENGLISH
INTRODUCTION
Metal Power bank 12000 mAh is a portable battery used for charging of hardware devices (e.g., mobile phones,
GPS navigators, tablets, music players) when travelling. Thanks to the 12000 mAh capacity it features a high
charging power.
The battery has two output USB ports (USB type A) for charging the connected devices and one input USB port
(Micro USB type) for charging the power bank itself. Supplied with micro USB cable.
SPECIFICATION
?Battery type: Lithium Polymer
?Capacity: 12000 mAh
?Charging time: 12-13 h
?Output / input voltage: DC 5 V / DC 5 V
?Output current: max. 2x 1000 mA for hardware devices connected on each port or max. 2100 mA for one
device connected on the 2.1 A port
?Number of charging / discharging cycles: min. 500
?4 LED diodes indicating the corresponding battery capacity level
?Protection: against high current, overcharging or discharging of the batteries in the connected devices,
against excess voltage, low voltage, short circuiting
?Intelligent charging control and monitoring, LED indication
?Control by a single button ON/OFF
?Automatic switching off when idle extended battery life
?Dimensions: 155 x 72 x 14 mm (l x w x h)
?Operating temperature: -10ºC ~ 40ºC, storing temperature: -20ºC ~ 50ºC
CONTROL
A: Charging the power bank:
1. Check the charging / capacity level (see point C and D) and charge the power bank as necessary. Using the
included micro USB cable connect the input USB port of the power bank to the USB port (USB 2.0/3.0) of your
notebook / PC or to a 230 V USB charger (e.g. i-tec USB Power Quatro Charger 4 Port).
2. The charging level is indicated by 4x LEDs (see point D).
Note: During charging of the power bank it is not possible to simultaneously charge the connected USB equipment.
B: Charging of the connected devices:
1. Using the included micro USB cable (or using the original USB cable of the charged devices) connect the device
to the output USB port of the power bank (USB type A). Make sure that the cable is properly connected to the
device.
2. Charging will start within 5 s or press the ON/OFF button to start charging. Check the charging status on the
connected device. If during charging you disconnect the device from the power bank and connect it again after a
while, charging may not restart automatically (e.g., in case of iPhone 5). In this case restart charging by a long
pressing of the ON/OFF button on the power bank.
3. During charging of the connected devices the 4x LEDs on the power bank are ON (see point D).
C: Turning ON the LEDs (power indicator):
1. Press the ON/OFF button on the power bank – the 4x LEDs indicating the charging level will go ON (based on the
capacity). If no charged device is connected, all LEDs will turn OFF within approx. 15 s.
2. When the LEDs are flashing then the capacity is low and it is necessary to recharge the power bank.
3. If no light goes ON after pressing the ON/OFF button then the capacity is zero (it is necessary to recharge the
power bank) or the power bank has a defect (contact your claim-handling department) and return the product.
Quick Start
EN
06
EN
G
L
I
SH
D: Power bank LED power indicator:
Four LEDs are ON: 100%
Only three LEDs are ON: 75%
Only two LEDs are ON: 50%
Only one LED is ON: 25%
CONTENT OF THE PACKAGING
?Metal Power bank 12000 mAh
?Micro USB cable (100 cm)
?Manual
CAUTION
?Recharge the power bank at least 1x in 4 months in case the power bank is not used.
?Keep the power bank in a dry place with a constant temperature to avoid corrosion of the internal electronics
and the battery.
?Avoid falling of the power bank and do not drop it into fire.
?If the power bank cover is damaged or inflated do not use the power bank.
?Check the proper voltage, current and power input for the connected devices.
?Do not unnecessarily keep the adapter connected; disconnect it when not used.
FREQUENTLY ASKED QUESTIONS
Question: The power bank will not charge the device.
Answer: Unfortunately, despite the European standard on compatibility of charging equipment, some companies
protect their brand products and these can be charged only by the original / licensed charging adapter.
Question: After pressing the ON/OFF button no light goes ON on the power bank.
Answer: The capacity is zero (it is necessary to recharge the power bank) or the power bank has a defect (contact
your claim-handling department) and return the product.
Question: The device connected to the included micro USB cable will not charge.
Answer: Make sure that the cable is properly connected to the device.
Note: Marking is in compliance with EU Directive 2002/96/EC and EN50419
English
This equipment is marked with the above recycling symbol. It means that at the end of the life
of the equipment you must dispose of it separately at an appropriate collection point and not
place it in the normal domestic unsorted waste stream. This wil benefit the environment for
all. (European Union only)
Deutsch
Dieses Produkt trägt das Recycling-Symbol gemäß der EU-Richtinie 2002/96/EC. Das
bedeutet, dass das Gerät am Ende der Nutzungszeit bei einer kommunalen Sammelstelle
zum recyceln abgegeben werden muss, (kostenloss). Eine Entsorgung ûber den Haus-
/Restmûll ist nicht gestattet. Dies ist ein aktiver Beitrag zum Umweltschutz. (Nur innerhalb
der EU).
Èeština
Toto zaøízení je oznaèeno výše uvedeným recyklaèním symbolem. To znamená, že na konci
doby života zaøízení musíte zajistit, aby bylo uloženo oddìlenì na sbìrném místì, zøízeném
pro tento úèel a ne na místech urèených pro ukládání bìžného netøídìného komunálního
odpadu. Pøispìje to ke zlepšení stavu životního prostøedí nás všech. (Pouze pro Evropskou
unii).
Polski
To urz¹dzenie oznakowane jest specjalnym symbolem odzysku. Pookresie u¿ytkowania
trzeba je zwrócic do odpowiedniego punktu zbiörki i nie wolno umiestczaæ go razem z
nieposortowanymi odpadami. Takie dzialanie przyniese korzyœæ dla œrodowiska. (Tylko w
Unii Europejskiej).
Lietuvos
Ðis gaminys yra paþymëtas specialiu atliekø tvarkymo þenklu. Baigus eksploatacijà,
gaminys turi bûti atiduotas á atitinkamà surinkimo punktà ir negali bûti ðalinamas kartu su
nerûðiuojamomis atliekomis. Tokie Jûsø veiksmai prisidës prie aplinkos apsaugos. (Tiktai
Europos S¹jungoje).
European Union Only
WEEE
17
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20

iTEC PB12000 Datasheet

Category
Power banks
Type
Datasheet

iTEC PB12000

Below you will find brief product information for iTEC PB12000. This portable battery, with a capacity of 12000 mAh is used for charging hardware devices (e.g., mobile phones, GPS navigators, tablets, music players) when travelling.

iTEC PB12000 has two output USB ports (USB type A) for charging the connected devices and one input USB port (Micro USB type) for charging the power bank itself. Supplied with a micro USB cable, it features four LED diodes indicating the corresponding battery capacity level.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages