Installation Guide
For Sweden Bathroom Accessory Series
Installation:
Follow these steps for installation.
Approx. 23.5”
Prepare fastener holes for attaching
the mounting plates using options below:
A. Attaching to stud in drywall.
B. Attaching to drywall.
Attaching to stud in drywall:
Use drill bit smaller than the screws to
pre-drill holes.
Attaching to drywall:
Use drill size appropriate for wall
anchors. Tap each anchor in wall with
hammer.
Attach each mounting plate to wall by
installing screws into pre-drilled wall
anchor holes. (Robe holder accessory
must be positioned vertically.)
The accessory is now securely in place.
Attach accessory to the mounting plate
Use provided hex key to tighten the hex
head located on the underside of the
accessory to secure the product.
Tools you will need
Tool Checklist.
Important: Please use the provided beige wall anchors for drywall-only
installation. To use, follow the above-referenced steps, but concurrently
screw in both screw and beige wall anchor into wall.
For installation on tile surface/wall, please seek professional assistance at
your local hardware store or consult a licensed contractor. Please note tile
installation requires a tile drill bit.
1. 2.
3.
5.
4.
2a.
2b.
www.boannstyle.com
Accessory
BOANn
Side View
For Towel Bars : Using a level and
measuring tape, measure the distance
between mounting plates. Mark Screw
points with tip of screwdriver or pencil.
(For other accessories, skip to step 2)
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Dyconn Faucet BATPH-CHR Installation guide
-
Dyconn BLN4SET24-ORB Operating instructions
-
-
Dyconn BA4SET24 Installation guide
-
Glacier Bay 391SSHD Installation guide
-
Kallista P34708-00-CP Installation guide
-
American Standard 2555.051 User manual
-
American Standard 2555.021 Installation guide
-
Peerless Industries PRG-1W User manual
-
