Datexx DRC-6082 Owner's manual

Brand: Datexx

Model: DRC-6082

Type: Owner's manual

Getting Started

“SNOOZE / LIGHT” button

Projector lens

Motion sensor

▼“button”

▲“button”

“MODE” button

“FLIP” button

“ ” button

DRC-6082 RC Projection Clock with Motion Sensor

3 to 5 minutes

for search

Signal Recieved

Date and Time are Set

Signal Not Working

Press and Hold the Up and Down Keys

Simultaneously Until the radio Tower

Symbol Blinks. Signal Search Will

Begin Again

Note: If signal does not work, please set time manually

Manual Setting

Power

Turn On Projection

Click Swith On Back

To The ON Position

Time Search

Clock Will Search For

Exact Time

Time Zone

▲

Set Year

Set Month

Mode

▲” or “▼

Use

Set Day

Set Hour

Set Minute

Set Temp

Mode

▲” or “▼

Use

Hold 3 Seconds

Mode

▲” or “▼

Use

Mode

▲” or “▼

Use

Mode

▲” or “▼

Use

Mode

▲” or “▼

Use

Set Time

Mode

Set 12 / 24 Hr

▲

(optional)

2 AA Batteries required to run the clock (Not included)

AC Adapter to run Projected (Included)

Hold down

arrow till your time

zone shows on map.

Note:

Batteries must be installed,

and AC Adapter plugged in

for clock to work.

Limited Warranty (USA Only)

TELEDEX Inc. Kenilworth, NJ 07033 USA

Printed in China

TELEDEX Inc.

1 Atlas St., Kenilworth, NJ 07033

Teledex Inc. (Datexx) warrants its products

to be free from defects in workmanship

and materials, under normal use.

Datexx products carry a standard one year

limited warranty from the date of purchase.

Please contact us by email: [email protected]om

Moving your hand directly over the motion sensor up to 30 cm away illuminates the display

for approximately 5 seconds.

It is not possible to illuminate the display cont

inuously. Please note that more power is

required to illuminate the display, which can result in reduced battery performance.

Light Projection

Continued projection

For the continued projection of the time or

alternating displays of time,

the batteries must be installed

and the atomic projection clock must be operated with the

included adapter.

Maintenance and Care

Do not throw the product

into ﬁre

Do not attempt to disassemble

or alter the product

Do not immerse the product

in water or other liquids

Do not use alcohol, benzene,

thinners to clean the product

To clean the product, wipe it

with dry, soft cloth

Flip

90°

Motion Activated

Time Projection

Alarm Setting

Turn Off Alarms By Pressing The Alarm 1 or

Alarm 2 Buttons. The Alarm Symbol will

Disappear

Set Alarm 1

▲” or “▼

Use to Set Hour

Hold 3 Seconds

▲” or “▼

Use to Set Minute

▲” or “▼

Use to Snooze Time

Alarm 1 Set

will appear on the LCD

Set Alarm 2

Hold 3 Seconds

Follow above steps

Press Snooze / Light Button

to activate Snooze

Time Projection

“ROTATE” control dial

“FOCUS” control dial

Pivoting projection arm

90° forwards 90° backwards

Press Snooze / Light Button

Motion Sensor Projection

Press Snooze / Light Button

Press the Flip Button for

Alternative Projection Angles

Projection arm moves

forwards and backwards 90°

Note:

Only time is projected,

not temperature

Datexx DRC-6082 Owner's manual

Datexx DRC-6082 Owner's manual

Datexx DRC-6082 Owner's manual

Related papers

Other documents