MirrEdge 84112 Operating instructions

Brand
MirrEdge
Model
84112
Type
Operating instructions

This manual is also suitable for

Installation Instructions
Instrucciones de Instalacion
1. Measure mirror height &
width. Vertical Strips full
height. Horizontal Strips
deduct 3.5 inches.
1. Mida el espejo. Las tiras
verticales a la altura total. Las
tiras horizontales descontando
3.5 pulgadas.
2. Score a line on front of
strip to the measured length.
2. Marque una línea en la
3. Hold strip firmly with both
hands near score line, crisp-
ly bend hands down to snap
strip.
3. Sostenga la tira firmemente
con ambas manos cerca de la
linea marcada y súbitamente
dóblela con las manos para
4. Apply adhesive tape
squares to back of strips
approximately 8”-10” apart.
Then apply small dabs of
adhesive glue (Liquid Nails®
Model LN-700) next to tape
squares. Repeat with Corner
and Cover Seam Plates if
used.
DO NOT APPLY GLUE ON
TOP OF TAPE SQUARES.
4. Cuadrados de cinta doble
cara y pequenos toques de
adhesivo separados aprox. 8”-
10”. A continuación, aplicar
pequeñas pinceladas de pega-
mento adhesivo junto a cuad-
ros de cinta. Repita con la
esquina y placas de cubierta
de costura. (No appliqué peg-
amento adhesivo en la parte
superior de los cuadrados de
cinta.)
As Seen In Handy™ Magazine
5. Place the vertical strips
first, then the horizontal
strips around perimeter of
mirror.
5. Coloque las tiras verticales
primero y luego tiras horizonta-
les alrededor del perímetro del
espejo.
Seam Cover Plates (Sold
Separately) are used to hide
seams when using multiple
strips for mirrors exceeding
60” in length.
Las Placas para cubrir se usan
para ocultar las uniones cuan-
do se utilizan múltiples tiras
para espejos de mas de 60” de
largo.
Only use Liquid Nails Adhe-
sive® LN-700 For Small Pro-
jects or MirrEdge™ Adhe-
sive.
Solamente use Liquid Nails®
LN-700 o el pegamento
MirrEdge®.
DO NOT USE CLEANERS
CONTAINING AMMONIA
NO USE LIMPIADORES QUE
CONTENGAN AMONIACO
For more information, visit
www.mirredge.com
Por más informacion:
www.mirredge.com
Manufactured by
Fabricado por
Millennium International
Development Corporation
Boca Raton, FL USA
6. Complete corner areas by
affixing corner plates on top
of strips in each corner.
6. Primero pele aproximad-
amente 4 - 5 pulgadas de capa
protectora de las tiras. Áreas
de esquina en la parte superior
de las tiras en cada esquina.
  • Page 1 1

MirrEdge 84112 Operating instructions

Brand
MirrEdge
Model
84112
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents