Form No. 778-11914© 2010 11A-074
Use cable ties to secure cables to
lower handle.
Remove and discard the retainer clip found A.
on the chute deflector.
Lift handle upward into extended position. B.
Tighten handle knobs. C.
Secure the wheels to the deck as
shown. The crown side of the bell
washer should be facing the wheel.
Use the same index hole (i.e. lower,
middle or upper) for all four wheels.
Hold blade control handle against upper handle. A.
Slowly pull starter rope handle from engine and B.
slip starter rope into the rope guide.
Tighten rope guide wing knob.C.
A
A
B
B
C
C
Starter
Rope Handle
Blade Control Handle
Handle Knobs
Tools Required:
• ⁄-inch wrench (or adjustable wrench)
• ⁄-inch wrench (or adjustable wrench)
1
3
2
4
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U