Crossco PB023-5 Installation guide

PERMA BOND REGULAR

CODE: PB023

DESCRIPTION

Crossco Perma Bond is a plaster to concrete bonding agent ready to use that

provides a permanent bond between structurally sound substrates and

lime plaster. Creates a strong bond between old and new plaster and/or

stucco.

USES Concrete

ADVANTAGES *fast dry *ready to use

*non-toxic *excellent bond

*water clean-up *creates strong bond

PRODUCT CHARACTERISTIC

Appearance………………………

liquid Viscosity ……………….. 95-100

Color…………. blue/white/pink Application Rate……………… 350 sq.ft.

Solid/Weight …………… 28% +/- 1%

1.13 Weight/Gal ………………. 9.05 lbs +/-

Solubility………. Soluble

Drying Time: 2-4 hour

APPLICATION

Crossco Perma Bond is ready tu use. Apply a uniform coat of bonding agent

to existing surface with brush, roller or airless spray. Make sure all areas are well

covered with product. After application, allow 2 to 4 hours to dry before applying

plaster/stucco to surface. Trowel on plaster/stucco on a circular motion.

If product is left on surface longer than 48 hours, an adittional coat is

required.

CAUTION

Keep out of reach of children.

If skin contact occurs, wash inmediately with soap and water, seek medical help as

needed.

If eye contact occurs, flush inmediately with clean water and seek medical help.

In case of ingestion, seek medical help inmediately.

Dispose of waste material in accordance with Federal, State and Local requirements.

For chemical emergency only, call Chemtrec 1-800-424-9300

PACKAGING

5 US GAL

55 US GAL