2. DV8 OFFROAD
  3. RRGL-01

DV8 OFFROAD RRGL-01 Installation guide

  • Hello! I've reviewed the installation instructions for the DV8 Chase Rack RRGL-01. The document provides a step-by-step guide on how to mount the rack to the bed of a 2020+ Gladiator truck including light installation. I'm ready to assist you with any questions you have.
  • What size hardware is used to mount the center section of the rack?
    Do I need to remove any factory bolts to install the rack?
    What type of light bars are compatible with the rack?
2020+ Gladiator Chase Rack (RRGL-01)
1. Begin by removing all items from packaging and inspecting them.
2. Take the center section of the rack and using the larger M10 supplied hardware,
mount it to either side of the chase rack as shown.
a. NOTE: We already installed our lights which can be done prior to install or after
install as well.
3. Once loosely attached, bolt the other side of the rack as well. With additional help, lift
rack onto bed of Gladiator. Align the two holes on front of the truck. If you haven’t
already, remove factory bolt from this position since you will reuse it for the rack.
4. Loosely install bolt into rack on the front of the bed.
5. Install bed clamp brackets using shown M8 hardware. The bed clamp brackets need to
be secured into place by folding them from the bottom to the top as shown.
6. Tighten down the front bed bolt, then tighten down the clamps until rack is secured.
The hole above the factory bolt can either be thru bolted or can be used to add an
eyelet for a tie down point.
7. Install lights if going to be used. Note, the two smaller light brackets are for the 10” on
the underside of the rack, and the larger brackets are for the 50” single row on top.
8. Enjoy your new DV8 Chase Rack!
Please contact [email protected] or 951-680-9595 if you have
any questions!
/