KegLand KL09348~KB05449 Operating instructions

Brand
KegLand
Model
KL09348~KB05449
Type
Operating instructions
WHAT IS IN THE KIT:
INSTRUCTIONS:
CLEANING & SANITATION
Clean and sanitise all brewing equipment that will come into contact with your beer (including fermenter,
fermenter lid, mixing paddle/spoon, thermometer, air lock etc.) with a quality no-rinse sanitiser, such as StellarSan
(KL05357). Refer to the instructions on the label of your no-rinse sanitiser for dosage and usage.
1
THE MASH
Heat 43.42L of strike water to 71°C (or the correct temperature to achieve a mash temperature of 65°C ). If using
brewing salts, add 8.9g Calcium Chloride, 7.7g Epsom Salt, 7.7g Gypsum (Note - these additions are based on a Reverse
Osmosis base water prole).
Once strike temperature is achieved, add your pre-milled malt and stir thoroughly to ensure there are no dough balls.
Check the temperature – we are aiming for a mash temperature of 65-66°C . Adjust as needed.
Let the grain bed sit for 10 minutes, then begin recirculation. Mash for a total of 60 minutes. Preheat 15.33L of sparge
water to 75°C towards the end of the mash.
Once the mash is complete, li the malt pipe and drain the wort. Add your sparge water at 75°C to the malt pipe.
Once the sparge is complete, begin the boil by turning the elements to full. You should end up with around 52L of
wort for the boil.
2
KegLand Distribution Pty Ltd© - Coastbusters WC IPA (All Grain Recipe Kit)
1 x Pre-milled All Grain Malts
4 x Lallemand Diamond LagerYeast
1 x 100g Hallertau Blanc Hops
Juggernaut
Meet Märzen Attacks! This is our really not very traditional take on a truly classic style, the Märzen or
Märzenbier. Malty. rich, and bursting with avour. This version is, well, I'm not gonna say red, but hold it up to
the light and you will see a beautiful ruby glow. Perfectly balanced, malt forward and fantastic.
Are you ready to dip your toes in the wonderful world of dark lagers?
42 litres
22 (Est.)
1.056
1.012
5.8%
31 EBC
Volume
IBU’s
OG
FG
ABV
Colour
BREW SPECIFICATION
Juggernaut
THE BOIL
3
MY RATING:
APPEARANCE
TASTE
OVERALL
AROMA
1 2 3 4 5
EMAIL US 24/7
beer@kegland.com.au
BREW DAY QUESTION?
Our friendly sta are
ready to help!
KegLand Distribution Pty Ltd© - Coastbusters WC IPA (All Grain Recipe
There is one boil hop addition for this recipe. Add 36g Hallertau Blanc as
soon as the boil begins (60 minute addition).
Boil the wort for 60 minutes in total. Pay attention at the start of the boil to
avoid any boilovers.
Once the boil has nished, you can transfer the wort. If using the No Chill
method, simply pump it directly into your clean and sanitised No Chill cube.
Otherwise, chill using your desired method and transfer to your fermenter.
4THE FERMENTATION
Ensure that your fermenter has been thoroughly cleaned and sanitised. If
using an airlock, half ll it with sanitiser at the correct dilution. Add the
cooled wort to the fermenter and pitch the yeast by sprinkling directly onto
the cooled wort.
If you are using temperature control, the ideal schedule for this beer is 13°C
for the rst 5-7 days, then raise to 18°C once fermentation is almost
complete until fermenation is nished. Raising the temperature at the end
of fermentation is known as a diacetyl rest, and is important especially with
lager yeasts to ensure full attenuation and to allow the yeast to clean up the
o avours that can be produced as a result of fermentation.
The absolute best way to ensure you get consistently great beer is to get a
small cheap/free fridge from Gumtree and make a fermentation chamber.
This can be done easily with an inexpensive temperature controller
(KL01946) and a heat belt (KL01953). You just plug the fridge and heat belt
into the temperature controller and put the fermenter in the fridge, dial in
the temperature and forget about it!
6
5
Lager yeasts are ideal for pressure fermentation. Using pressure allows for a fast and clean fermentation. We
recommend not letting pressure build for the rst 24 hours, as that can inhibit yeast growth, but aer that, using
spunding, allow the pressure to ramp to between 10-18psi. Once the desired pressure has been reached, the
temperature can be raised to 16-18°C until nal gravity has been reached. With this temperature/pressure combi-
nation, you will most likely experince quite a fast fermenation with Lallemand Diamond Lager yeast.
Note that you must have a pressure capable fermenter such as a 30L FermZilla All Rounder for pressure
fermention. Please ensure that a spunding valve such as a KB03529 Integrated Gauge Blowtie Spunding Valve is
used to control the pressure in the fermenter. Failure to do so can result in excess pressure build up which can be
dangerous..
Once fermentation is done, it is time to transfer your nished beer! Ideally, cold crashing for at least 48 hours will
give the best results before transferring.
To determine that fermentation has nished, check the gravity over three consecutive days. If it is stable across
three consecutive days then fermentation is done and the beer can be safely transferred to your bottles, cans or
keg. Do not transfer until fermentation is complete.
Bottling your beer: Please refer to our detailed beginners guide for bottling from a fermenter here:
https://www.kegland.com.au/blog/post/a-beginners-guide-to-bottling-homebrew
Kegging your beer: We would suggest carbonating and dispensing at 10-12 psi at 2°C for best results. Refer to
our detailed beginners guide for kegging from a fermenter here:
https://www.kegland.com.au/blog/post/how-to-keg-your-beer-a-basic-guide
Canning your beer: To transfer your nished beer into cans we would suggest kegging and carbonating at 11psi
at 2°C then transferring to cans. Refer to our detailed beginners guide for canning here:
https://www.kegland.com.au/blog/post/how-to-can-your-beer-a-beginners-guide
THE TRANSFER
FERMENTING UNDER PRESSURE
  • Page 1 1
  • Page 2 2

KegLand KL09348~KB05449 Operating instructions

Brand
KegLand
Model
KL09348~KB05449
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents