Page is loading ...
CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
iCDK658
CDK658 Mounting Kit
DODGE
2014-15 DURANGO
JEEP
2014-15 GRAND CHEROKEE
VEHICLE APPLICATIONS
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 7/15 PRINT Ver. 07/15
WWW.AIUS.NET
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
Canada Sales (888) 922-3006
For information about other American International automotive
accessories visit our website at:
http://www.aius.net
1. Using a soft tool unsnap the panel surrounding the radio that includes
the climate controls. Unplug all harnesses. Remove.
2. From the OEM radio remove (4) Phillips screws. Remove Radio.
Unplug all harnesses and antenna connections.
3. From the OEM panel remove the trim from the radio opening. Saving 3 screws for kit
assembly. Also remove 2 plastic retainer clips for use on the OEM panel support
supplied with the CDK658.
DASH DISASSEMBLY
1 2
KIT ASSEMBLY INSTRUCTIONS
1. Install the OEM panel support supplied with the CDK658 to the back of the OEM
panel above the radio opening using 3 screws from the radio opening trim, also
adding the 2 plastic retainer clips.
2. Install ISOBRK2 brackets to rear of main frame .
3. Insert pocket into lower section of the ISOBRK2 brackets
4. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides
of radio using screws provided with radio when possible, or screws supplied with kit.
5. Using the main frame of the CDK658 as a guide, slide radio forward or backward
for desired look and then tighten screws to the radio.
NOTE: Check mounting depth available, it may be necessary to relocate OEM module
to achieve enough depth in dash to mount radio.
Single ISO Mount Applications
Double DIN Mount Applications
Fig B
1. Install the OEM panel support supplied with the CDK658 to the back of the OEM
panel above the radio opening using 3 screws from the radio opening trim, also
adding the 2 plastic retainer clips.
2. Install ISOBRK2 brackets to rear of main frame .
3. Insert ISO mountable radio between ISO mount brackets and loosely
attach to sides of radio using screws provided with radio when possible,
or screws supplied with kit.
4. Using the main frame of the CDK658 as a guide, slide radio forward or backward
for desired look and then tighten screws to the radio.
NOTE: Check mounting depth available, it may be necessary to relocate OEM module
to achieve enough depth in dash to mount radio.
Fig A
Remove shaded tabs
on left and right sides
of the main frame for
JEEP GRAND
CHEROKEE ONLY
Remove shaded tabs
on left and right sides
of the main frame for
JEEP GRAND
CHEROKEE ONLY
Includes OEM panel support
/