EarthWay 91048 Operating instructions

Brand: EarthWay

Model: 91048

Type: Operating instructions

This manual is also suitable for

91030
91036

P95024_P95048_M52135_Rev_Nov2019

PAGE 1

ASSEMBLY

PROFESSIONAL

SNOW PUSHER

24”, 30”, 36” & 48” ASSEMBLY INSTRUCTIONS

Attach pusher blade to pusher support

by inserting

into center hole at top

of blade. Thread nut onto bolt but do

not tighten. Insert all hex nuts into back

of pusher support.

Grasp pusher blade support by shaft,

ex blade to insert second

into

middle hole at center of blade.

HARDWARE

Stainless Steel

1/4” Hex nut (4)

Lynch pin (1)

Stainless Steel

1/4” x 20 Bolt (4)

Stainless Steel

#8 5/8” Phillips

screw (2)

P95024_P95048_M52135_Rev_Nov2019

PAGE 2

ASSEMBLY

Insert handle shaft

into pusher support

Open

lynch pin and insert through hole

at top of pusher support. Insert from back of

support towards front (specically designed to

be snug in this direction).

Install remaining two screws

into

lower two holes of pusher support.

Insert LH and RH bolts

through

remaining blade holes

TIGHTEN ALL BOLTS, USE NEEDLE NOSE

PLIERS TO TIGHTEN NUT FROM STEP 1.

P95024_P95048_M52135_Rev_Nov2019

PAGE 3

CUSTOMER SERVICE

574.848.7491 | [email protected] | WWW.EARTHWAY.COM

1-YEAR LIMITED WARRANTY

EarthWay Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 1-Year to the end user with the original

purchase receipt. If a manufacturing non-conformance is found, EarthWay Products, Inc. at its discretion will repair or replace the part(s) or product at no

charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering, or normal wear and tear as determined by EarthWay.

EarthWay at its discretion may require that the part(s) or product be returned along with the original purchase receipt for examination and compliance

with the terms of this warranty. Do not return any product without rst receiving authorization from EarthWay Products, Inc. To seek remedy under this

warranty, contact EarthWay Products, Inc. at 574-848-7491, [email protected] or write to EarthWay Products, Inc. 1009 Maple Street, Bristol, IN 46507

and describe the nature of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges associated

with repair or replacement of non-conformances are specically excluded. Due to the corrosive nature of most fertilizers and ice melt products, EarthWay

Products, Inc. makes no warranty against and specically excludes part(s) or product degradation or failure due to corrosion or its eects.

PARTS LIST

99003 PUSHER SUPPORT

PUSHER BLADE

99002 FIBERGLASS HANDLE SHAFT

99001 D-HANDLE

99050 24” SHOVEL BLADE

99051 30” SHOVEL BLADE

99052 36” SHOVEL BLADE

99053 48” SHOVEL BLADE

38002 HARDWARE PACK

(QTY 1) (QTY 4) (QTY 4) (QTY 2)