EarthWay Polar Tech 2040PI-PLUS Assembly Instructions

Type
Assembly Instructions
P2040PI_M52214_Rev_Dec2019
PAGE 1
65LB ICE MELT
SPREADER
MODEL #2040PI-PLUS ASSEMBLY INSTRUCTIONS
1
Remove spreader from carton and pull handle into
position shown at right. Tighten wingnuts to secure.
2
Install Control Rod
into handle as shown above.
TIP: Install the Control Rod using
pliers to squeeze into Lever.
3
ROTATE FORWARD
4
Insert Control Rod into
Pivot and secure with
Hair Pin Clip.
ASSEMBLY
HELPFUL HINTS
Your spreader is almost ready to use. Attaching the control rod and unfolding the handle will require a pair of pliers
to insert pins to secure the control rod. NOTE: The large opening is designed to allow ice melt to ow through
spreader without the need for an agitator.
+ Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed.
Slower or faster speeds will change the spread patterns.
+ Priortoyourrstuse,coatallmetalparts(insideandoutsidetubing)withWD-40orotherspraylubetohelp
prevent corrosion.
+ Cleanyourspreaderthoroughlyaftereachuse.Washwithcleanwateranddrythoroughlyandspray
alightcoatingofoilonallmetalparts(insideallofthetubing)tohelppreventcorrosion.
+ Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
P2040PI_M52214_Rev_Dec2019
PAGE 2
CONTROL ROD KIT - 79015
CUSTOMER SERVICE
574.848.7491|[email protected]|WWW.EARTHWAY.COM
1-YEAR LIMITED WARRANTY
EarthWayProducts,Inc.warrantsthisproductfreeofdefectsinoriginalworkmanshipandmaterialsforaperiodof1-Yeartotheenduserwiththeoriginal
purchasereceipt.Ifamanufacturingnon-conformanceisfound,EarthWayProducts,Inc.atitsdiscretionwillrepairorreplacethepart(s)orproductatno
chargeprovidedthefailureisnottheresultofincorrectinstallation,mishandling,misuse,tampering,ornormalwearandtearasdeterminedbyEarthWay.
EarthWayatitsdiscretionmayrequirethatthepart(s)orproductbereturnedalongwiththeoriginalpurchasereceiptforexaminationandcompliance
withthetermsofthiswarranty.DonotreturnanyproductwithoutrstreceivingauthorizationfromEarthWayProducts,Inc.Toseekremedyunderthis
warranty,contactEarthWayProducts,Inc.at574-848-7491,[email protected]orwritetoEarthWayProducts,Inc.1009MapleStreet,Bristol,IN46507
anddescribethenatureofthemanufacturingdefect.SPECIFICLIMITATIONS:Thiswarrantycoversonlythepart(s)orproduct;anylaborchargesassociated
withrepairorreplacementofnon-conformancesarespecicallyexcluded.Duetothecorrosivenatureofmostfertilizersandicemeltproducts,EarthWay
Products,Inc.makesnowarrantyagainstandspecicallyexcludespart(s)orproductdegradationorfailureduetocorrosionoritseects.
PARTS LIST
TIRE KIT - 79017
IMPELLER & GEAR BOX KIT - 79016
Nut (1) Bolt (1) Control Assy
(1)
Hair Pin Clip
(1)
Control Rod (1)
Tire (1)
Cotter Pin (1)
Washer (1)
Impeller (1)
Gear Box (1)
  • Page 1 1
  • Page 2 2

EarthWay Polar Tech 2040PI-PLUS Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI