Rain Wizard RW40-BLK Installation guide

Directions For Setting Up Your RainWizard

You Will Need:

- A small wrench to tighten spigot

- A screw driver to remove the screen.

1) Remove the screen from the top of your rain

barrel.

2) Inside you will find a roll of Teflon tape and a

brass spigot. Remove these items from the rain

barrel.

3) Wrap a length of Teflon tape around the threaded

end of the brass spigot to ensure a leak free seal.

4) Screw the brass spigot into the hole on the front

of the barrel and tighten with a small wrench.

This manual is also suitable for