Directions For Setting Up Your RainWizard
You Will Need:
- A small wrench to tighten spigot
- A screw driver to remove the screen.
1) Remove the screen from the top of your rain
barrel.
2) Inside you will find a roll of Teflon tape and a
brass spigot. Remove these items from the rain
barrel.
3) Wrap a length of Teflon tape around the threaded
end of the brass spigot to ensure a leak free seal.
4) Screw the brass spigot into the hole on the front
of the barrel and tighten with a small wrench.
/
