2. CyberData
  3. 011388

CyberData 011388 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the CyberData 011388 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Acrylic Bezel Installation / Removal
1) A Size Number 1 Phillips Screwdriver
Tool Required to Perform this Task:
Machine Screw
#-4-40 Phillips Drive
Bezel Guide
Acrylic Bezel
Notch
Bezel Guide
Edge of the Table or Desk
Hookswitch Cradle
A Clean, Flat Surface
Step 2: Remove All Mounting Screw from the Faceplate with
Step 3: Slowly Remove Faceplate Assembly Away from the Backbox,
at the Same Time Disconnect the Hookswitch Connector * and
the Ground Wire **.
Step 4: Place Faceplate on the Clean and Flat Surface,
*
**
Provided T15H Security Torx Driver Bit.
Place Hookswitch Just Over the Edge of it,
so that the Facplate Remains Flat.
Step 5: Remove Bezel Guides Mounting Screws by Using the Phillips Screwdriver.
Step 6: Remove Damaged Acrylic Bezel from Faceplate.
Step 7: Remove Protective Films from the New Acrylic Bezel.
Step 8: Reverse the Steps You Just Performed.
Step 1: Find a Working Area.
This Place Require a Clean, Flat Surface (for Example: a Table or a Desk).
2) T15H Driver Bit (in the Provided Accessory Kit)
/