HP Compaq 6910p Notebook PC Getting Started

Getting Started

HP Business Notebook PC

Document Part Number: 442861-001

April 2007

This guide explains how to set up your hardware and

software, and begin using the computer in Windows

®.

Enhanced for Accessibility

Windows is a U.S. registered trademark of Microsoft Corporation.

Bluetooth is a trademark owned by its proprietor and used by

Hewlett-Packard Company under license.

The information contained herein is subject to change without notice.

The only warranties for HP products and services are set forth in the

express warranty statements accompanying such products and

services. Nothing herein should be construed as constituting an

additional warranty. HP shall not be liable for technical or editorial

errors or omissions contained herein.

Getting Started

HP Business Notebook PC

First Edition: April 2007

Document Part Number: 442861-001

Product notice

This user guide describes features that are common to most models.

Some features may not be available on your computer.

Getting Started iii

Contents

1 First-time setup

Identifying required hardware . . . . . . . . . . . . . . . 1–1

Setting up the computer. . . . . . . . . . . . . . . . . . . . 1–2

Step 1: Insert the battery . . . . . . . . . . . . . . . . 1–2

Step 2: Connect the computer to external

power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–3

Step 3: Turn on the computer . . . . . . . . . . . . . 1–4

Step 4: Set up the software. . . . . . . . . . . . . . . 1–5

Step 5: Create recovery discs (recommended) . 1–5

2 Quick tour

Identifying required hardware . . . . . . . . . . . . . . . 2–1

Top components . . . . . . . . . . . . . . . . . . . . . . 2–2

Front components . . . . . . . . . . . . . . . . . . . . . 2–4

Left-side components . . . . . . . . . . . . . . . . . . . 2–4

Right-side components . . . . . . . . . . . . . . . . . . 2–5

Rear components . . . . . . . . . . . . . . . . . . . . . 2–5

Bottom components . . . . . . . . . . . . . . . . . . . . 2–6

Wireless antennae . . . . . . . . . . . . . . . . . . . . 2–7

3Next steps

Protecting the computer . . . . . . . . . . . . . . . . . . . . 3–1

Protecting the computer from viruses . . . . . . . . 3–1

Protecting your system files . . . . . . . . . . . . . . . 3–2

Protecting your privacy . . . . . . . . . . . . . . . . . 3–2

Protecting the computer from power surges. . . . 3–2

Using the computer safely . . . . . . . . . . . . . . . 3–3

iv Getting Started

Contents

Connecting to a computer network . . . . . . . . . . . . 3–4

Installing additional hardware and software . . . . . 3–4

Identifying and installing hardware . . . . . . . . . 3–4

Locating and installing software . . . . . . . . . . . 3–5

Updating the software installed on the computer. . . 3–6

Finding the user guides . . . . . . . . . . . . . . . . . . . . 3–6

Turning off the computer correctly. . . . . . . . . . . . . 3–6

Removing the battery . . . . . . . . . . . . . . . . . . . . . 3–7

4 Troubleshooting

Troubleshooting resources . . . . . . . . . . . . . . . . . . 4–1

Quick troubleshooting . . . . . . . . . . . . . . . . . . . . . 4–1

The computer is unable to start up . . . . . . . . . . 4–1

The computer screen is blank . . . . . . . . . . . . . 4–3

Software is functioning abnormally . . . . . . . . . 4–4

The computer is turned on but not responding. . 4–4

The computer is unusually warm . . . . . . . . . . . 4–5

An external device is not working . . . . . . . . . . 4–5

The WLAN connection is not working . . . . . . . 4–6

Help and Support. . . . . . . . . . . . . . . . . . . . . . . . 4–7

Contacting technical support . . . . . . . . . . . . . . . . 4–7

A Backup and recovery

Creating recovery discs. . . . . . . . . . . . . . . . . . . . A–1

Backing up your information . . . . . . . . . . . . . . . . A–2

When to back up . . . . . . . . . . . . . . . . . . . . . A–2

Back up suggestions . . . . . . . . . . . . . . . . . . . A–2

Backing up specific files or folders. . . . . . . . . . A–3

Backing up the entire hard drive . . . . . . . . . . . A–4

Creating recovery points . . . . . . . . . . . . . . . . A–4

Scheduling backups . . . . . . . . . . . . . . . . . . . A–5

Performing a recovery. . . . . . . . . . . . . . . . . . . . . A–6

Performing a recovery from the recovery

discs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A–6

Performing a recovery from the hard drive . . . . A–6

Getting Started v

Contents

B Specifications

Operating environment . . . . . . . . . . . . . . . . . . . . B–1

Rated input power . . . . . . . . . . . . . . . . . . . . . . . B–2

Index

Getting Started 1–1

1

First-time setup

Identifying required hardware

To set up the computer for the first time, you will need the

computer, the AC adapter, the power cord, and the primary

battery.

Components included with the computer may vary by region and

by model.

✎

Component Component

1

Power cord

3

Primary battery

2

AC adapter

4

Modem cable (select models only)

Use only the AC adapter provided with the computer or one

approved for this computer.

The modem cable is required only for dial-up networking.

1–2 Getting Started

First-time setup

Setting up the computer

Computer setup involves the following tasks:

1. Inserting the battery into the computer

2. Connecting the computer to external power

✎

The battery begins to charge.

3. Turning on the computer

4. Setting up the software

5. Creating recovery discs (recommended)

✎

Refer to Appendix A, “Backup and recovery,” for

instructions.

Ä

CAUTION: Reduce the risk of file corruption by observing the following

practices during the hardware and software setup procedures:

■ Do not unplug the computer from external power.

■ Do not shut down the computer or initiate Standby or Hibernation.

Step 1: Insert the battery

To insert a primary battery:

1. Turn the computer upside down on a flat surface, with the

battery bay toward you.

2. Slide the battery 1 into the battery bay until it is seated.

The battery release latches 2 automatically lock the

battery into place.

Getting Started 1–3

First-time setup

Step 2: Connect the computer to external power

✎

Power cords and AC outlets vary in appearance by region and

country.

To connect the computer to external AC power:

1. Plug the AC adapter into the power connector 1 on the

computer.

2. Plug the power cord into the AC adapter 2.

3. Plug the other end of the power cord into an AC outlet 3.

When the computer receives AC power, the battery begins to

charge and the battery light (on the front of the computer)

turns on. When the battery is fully charged, the battery light

turns off.

Leave the computer connected to external power until the

battery is fully charged and the battery light turns off.

✎

A partially charged new battery can run the computer after

software setup is complete, but battery charge displays will not be

accurate until the new battery has been fully charged.

1–4 Getting Started

First-time setup

Step 3: Turn on the computer

To open the computer:

1. Slide the display release latch 1 to the right to release the

display.

2. Raise the display 2.

To turn on the computer:

» Press the power button 1.

The power light on the power button 2 turns on.

Getting Started 1–5

First-time setup

Step 4: Set up the software

After the computer is turned on, it will go through software

setup. Follow the on-screen instructions to set up the software.

Note the following points:

■ After you respond to the setup prompt, you must complete

the entire setup process without interruption. Setup time

varies.

■ During software setup, the computer may pause

periodically for several minutes. These normal pauses are

indicated by an hourglass icon.

Ä

If you are prompted to select an operating system language,

choose carefully. On some models, the languages that you do not choose

are deleted from the system and cannot be restored during software setup.

CAUTION:

✎

To register the operating system and the computer during software

setup, the computer must be connected by an RJ-45 (network) cable

to an existing network that has access to the Internet. If you do not

register during software setup, you can do so at any time after

software setup is complete.

Step 5: Create recovery discs (recommended)

You can create a set of recovery discs of your full factory

image using HP Backup and Recovery Manager. You can use

the recovery discs to start up (boot) the computer and restore

the operating system and software programs to factory

settings in case of system failure or instability.

Refer to Appendix A, “Backup and recovery,” for detailed

instructions.

1–6 Getting Started

First-time setup

Getting Started 2–1

2

Quick tour

Identifying required hardware

✎

Components included with the computer may vary by region and

model. The illustrations in this chapter identify the standard features

included on most computer models.

2–2 Getting Started

Quick tour

Top components

Lights

Component Component

1

Wireless lights (2)*

6

Num lock light

2

Power lights (2)†

7

Volume mute light

3

Battery light

8

Volume down light

4

Drive light

9

Volume up light

5

Caps lock light

*The 2 wireless lights display the same information. The light on the wireless

button is visible only when the computer is open.

The wireless light on the front of the computer is visible whether the

computer is open or closed.

†The 2 power lights display the same information. The light on the power

button is visible only when the computer is open. The power light on the front

of the computer is visible whether the computer is open or closed.

Getting Started 2–3

Quick tour

Buttons, switches and fingerprint reader

Component Component

1

Power button

9

Right pointing stick button

2

Info button

-

HP Fingerprint Sensor (fingerprint

reader)

3

Wireless button

q

TouchPad scroll zone

4

Presentation button

w

Right TouchPad button

5

Volume mute button

=

Left TouchPad button

6

Volume scroll zone

>

TouchPad

7

Internal microphone

?

Left pointing stick button

8

Pointing stick

2–4 Getting Started

Quick tour

Front components

Component Component

1

Wireless light

6

Infrared port

2

Power light

7

Media Card Reader

3

Battery light

8

Display release latch

4

Drive light

9

Bluetooth compartment

5

Speakers (2)

Left-side components

Component Component

1

Vent

5

Audio-out (headphone) jack

2

USB ports (2)

6

PC Card slot

3

1394 port

7

PC Card eject button

4

Audio-in (microphone) jack

Getting Started 2–5

Quick tour

Right-side components

Component Component

1

Smart card reader

4

RJ-45 (network) jack

2

MultiBay optical drive

5

RJ-11 (modem) jack

3

USB port

Rear components

Component Component

1

Security cable slot

3

S-Video-out jack

2

Power connector

4

External monitor port

2–6 Getting Started

Quick tour

Bottom components

Component Component

1

Bluetooth® compartment

6

Docking connector

2

Vents (5)

7

Accessory battery connector

3

WLAN module compartment

8

Memory module compartment

4

Battery release latches (2)

9

Hard drive bay

5

Battery bay

Getting Started 2–7

Quick tour

Wireless antennae

✎

T

R

c

Component Component

1 WLAN antennae (3)* 2 WWAN antennae (2)*

*The antennae are not visible from the outside of the computer. For optimal

transmission, keep the areas immediately around the antennae free from

obstructions.

o see wireless regulatory notices, refer to the section of the

egulatory, Safety and Environmental Notices that applies to your

ountry or region. These notices are located in Help and Support.

Page is loading ...

HP Compaq 6910p Notebook PC Getting Started

This manual is also suitable for

HP Compaq 6910p Notebook PC Getting Started

Related papers

Other documents